6-gear re-build

[Sharkman]

fellas,here's a pic of the gold tub I'm re-doin'.Still needs some parts,but I'm gaining on it.The whole back of the car is RPM parts,bulkhead,arms,and axle carriers,I also have the RPM front arms and steering bellcranks for it too.It should be alot of fun to run when it's done.here you go.

[MelvinsArmy]

Looks like a good start. Can't wait to see how it finishes up.

[bensb4]

i got almost all rpm stuff as well.you should just go for the rpm tranny like i did.all my rpm stuff came black:fr and rr arms,front rr hubs,front bulkhead,rod ends.

[Sharkman]

i didn't know RPM had a 6-gear trans case.I'd imagine tough to find.I just bought some parts from Scott,and a nice stock case came in the lot.Just have to sort the extras and put the trans together.Still need a few goodies,but it's getting close now.Probably just use Lunsford for T-buckles.

Anyone know if RPM still makes ball cups in white??Thanks.

[badhoopty]

check the ebay store section for white rpm ballcups.

i really wish rpm would still make white stuff....

[Sharkman]

Thanks Hoopster!!

[bensb4]

the rpm tranny is actually a 3 gear stealth 2.65 ratio conversion.it comes with a 18 tooth top gear instead of the 22t the stealth did.the case is the same size as the 6 gear tranny though....lol.
http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXEV49&P=7

down below where it says customers also bought is the idel and diff and 3/32 diff balls youd need.
i threw the blue ae ti turnbuckles on mine over the lunsford.heres the ones youd need if you change your mind
http://www2.towerhobbies.com/cgi-bin/wti0001p?&W=000179280&I=LXSF93&P=K
http://www2.towerhobbies.com/cgi-bin/wti0001p?&W=000179280&I=LXSF96&P=K
http://www2.towerhobbies.com/cgi-bin/wti0001p?&W=000179280&I=LXSF92&P=K

[Sharkman]

BB4,Thanks for the reply,I just came from towers site.My wishlist is a mile long LOL!! for RC 10 stuff.Thanks again.

[Sharkman]

All,Between sorting parts for a few builds,Here's where I'm at with my 6-gear car.Still needs tires,but I have a new Pro-Tech I
waiting 'til it's up on tires,hope you all like it.

[Sharkman]

anutha'

Many Thanks to Mr. Shodog for the rear end parts.

[templeofspeed]

Hey, what did you do with the RPM rear arms...?? I have a WTB in the B/S/T...

Sweet build BTW... looks like you went 6010 instead of CE

[Tadracket]

I want dem rims
That thing is looking sharp.

[Sharkman]

TOS The RPM arms are on another Gold tub of mine. Sorry those are not for sale.and yes,i went with the earlier car with this build.

I just updated my CE build thread also.

Tadracket,I hear you on "I want them rims"............but I need tires for them rims after that she'd be close to finished.

[templeofspeed]

TOS The RPM arms are on another Gold tub of mine. Sorry those are not for sale.and yes,i went with the earlier car with this build.

Thanks!