Hi all, the red Grasshopper was actually my first ever RC kit. I saved up paper route money to buy it.
(remember when kids had paper routes? Now some retired guy delivers papers in our community cause the kids today dont want to work for anything anymore...., bla bla bla OK i'll shut up)
The Thundershot was a really good car for me the picture is from 1988 I think!
Attachments
the good old days.jpg (170.07 KiB) Viewed 717 times
the good old days.jpg (170.07 KiB) Viewed 717 times
Hello everyone, I found this forum today and have been flooded with memories.
Here is my RC-10, I think it started as a ball bearing team car. At some point (after hacking the stock tub) I upgraded to the RPM front and rear with the double deck...
Last post
Very cool survivior from that era. they are a few really nice examples of these on the board.
I picked up a NISB B2-B3 conversion kit #9023 that I found deep within a hobby store's inventory.. (along with a pile of B2, B3, T3 parts). I couldn't find many pictures of #9023 here, but a few of #9022.
When the box says Graphite Conversion Kit...
Last post
Personally, I'd keep it a B2 if it were me. I also keep an eye out for a reasonably priced B2.
Hi all, I recently re-discovered an original RC10T kit that my uncle put together in the early 90`s. He assembled it and thats as far as he got, never ran it, never installed electronics. The kit # is 7011(if I remember correctly). Problem is though...
So does anyone know where to get a full bearing set for the 10T?? I bought a wheel bearing set recently that was too wide for the rears and would like to redo all the bushings to bearnigs. And if not a kit than bearing size/number of each size list....
Last post
Avid RC has bearings that you can buy individually. They are excellent quality too.