bearrickster wrote:I have never had a hot shot but that one on the Tamiya Club looks great. but what are these silver caps? their on the Hot trick one also? they look stupid do they do anything?
The heat sink is kind of symbol. It is equal to Hotshot.
Too early to know 'bormac', too late to know 'mrlexan', just in time to know 'murphy3428'. http://www.rc-lohas.com
I have almost finished a re re Hotshot and the silver caps are just dummys for looks because of the ESC in the re re. They used to be the heatsinks for the old manual speed controller on the original
Starting to put one of these together. Mainly because it was the first RC off road I built back when it came out. Shied away from it later because there were no parts available. You had to buy a whole kit to keep the suspension arms that seemed to...
so i been slowly working on my hotshot re-re.... finally got to the servo/electronics setup...
is there anyway to increase steering a bit on these cars? basically the steering is a direct servo turn (like frog and others). no bellcranks or anything...
Last post
Just wanted to update the ball raced steering option I have gone with. Obviously I have fabricated a base plate from 1.6mm fibreglass which is held in place through the original servo mounting holes. It took some working out to get this right. Ive...
I was reading the hotshot manual and was trying to figure out the type of ball bearing it needs. But there was no measurement in the manual.
Can someone tell me the type (size) and number of ball bearing in a hotshot? :roll:
Thnak you. :lol:
Last post
Yes, that's 4 more. That's why I buy 100 of them at a time... for $40. You can replace them as needed without going broke. Tamiya used 5x11 and 5x8 in almost all their 1980s releases (at least the ones that I have owned) and Traxxas did/does as...
Note that in figure 6, there is this thing called a 'motor' plate to be placed between the motor and the gearbox. I remember ta01 also has something like this, sort of like a thing piece of green/grey piece, it...
So, after replacing the stock 0 Degree Rear Pivot plate with the Trinity Aluminum Blue Pivot plate, with a different degree (don't know what it is) and it's also a bit wider, the MIP CVDs are now too short and don't stay in the axle drive cups....
I was very fortunate to have a chance to pick up this new built composite craft chassis kit with RPM worlds suspension from my LHS today. My question is did RPM make the worlds suspension arms in black or are these dyed ? Thanks in advance.
Last post
Thanks so much for the help, the reason I asked about the color is because the owner of the shop didn't recall dying the components black. I've attached a few more pictures for a closer look.
The measurement of the rear arm hinge pin to pin is 2...
Does anybody know why these 2 separate frontends would have the upper inside link mounts made 2 different ways? Maybe it’s a manufacturer mistake? I have a few of these cars and I see them all different. Either the hole is on the top or the side or...
Last post
Yeah it’s just strange that their all not drilled out the same. I’ll have to carefully drill them out.