LRP Sphere Competition setup problem.

Brushless, lipo, spectrum, etc...

Moderators: scr8p, klavy69

User avatar
askbob
Approved Member
Posts: 1736
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 4 times

LRP Sphere Competition setup problem.

Post by askbob »


User avatar
Charlie don't surf
Approved Member
Posts: 9242
Joined: Tue Apr 08, 2008 2:44 pm
Location: USA
Has thanked: 306 times
Been thanked: 415 times

Re: LRP Sphere Competition setup problem.

Post by Charlie don't surf »

Sounds like you have your transmitter E.P.A. settings somewhere other than 0, causing your throttle "throw" to be very very short from neutral to WFO ( an old trick of mine for stock oval ). Check all of them in your transmitter, make sure you have all expo settings at zero as well. Go back through the setup 1) hold set button for 3 sec until.you get a blinking blue light storing neutral 2) press set again and yellow/red and motor beeps, hold throttle open and 3) press set again holding full brake.

User avatar
askbob
Approved Member
Posts: 1736
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 4 times

Re: LRP Sphere Competition setup problem.

Post by askbob »

Thanks Reg. I was up way too late without much sleep to try and deal with that last night I suppose. :lol: Figured it out this morning once you spelled it out for me. On my 4pl, it must be that epa of 100 is actually 0. If I set it to 0, I get nothing with the throttle after finishing setup. Works like a champ now.

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post

Return to “Modern Electronics”

Who is online

Users browsing this forum: No registered users and 4 guests