I picked these up last week to experiment with. They didn't really cost much at all and they work :twisted:
I can program the Cyclone with my own custom parameters or use one of the 20 saved Novak sets to use as profile 4 on the Cyclone. Too bad I...
Last post
Wait, you have a computer with a serial port and diskette drive? :wink:
I'm a Mac guy in all honesty, but yes I do. I found it in the garbage and put XP on it :mrgreen: I use it mainly for the old school Toyota Electronic Parts Catalog Software...
I was thinking of getting a Super Vortex Zero soon but then I noticed there are now several different models of this ESC. There's the SV-Gen2, SV-Stock, SV-Type D and SV-Sport. What's the real difference between them?
I want to make sure I get a...
Last post
I run one in my b44.3. I'm happy with it. I'm running a little boost with my Reedy 7.5 and easily keep up with 6.5 cars. Runs nice and cool, even without using the fan. No complaints here. 8)
I have touched upon this ESC in my MMS thread just now as this is what came installed in the red MMS chassis car.
It is certainly from the British heatshrink era, but when I saw it I had zero clue what it was. The extremely neat soldering on the...
Last post
I must admit even though I was racing at that time, and Penn was my main model shop, I had never even heard of this 'VF' range until stumbling across this example. the whole car i bought was sourced from Penn Models along with all of the mods and...
In my build process, I now have 2 different ESCs. One is a novak 410-m5 and the other is a Traxxus xl-5 which is the yellow one. I know that the Novak has been around for a while, and that the Traxxus has several programmable modes.
Is there a...
Last post
Todd- if I knew what I had, I would certainly be much better off. The best I can find is a marking on the motor that says ROAR 91.
should be a 27t stock motor.
I have a pretty good collection of old Novak electronics and have seen just about everything out there but I have never seen or heard of this model before. It seems to be an early 1X chassis and the person I got it from said he purchased it in 1984....
Last post
Asso_man! thanks for posting the picture and a quick question, what material is that heat sink made out of aluminum? Also do you happen to have the dimensions of it? :D I did call Novak and they were very nice but they had no clue what this was....
I am pulling my hair out with this thing...It has a neutral and speed adjustment...Novak Solid state speed control is what it says on the case...I can not get the throttle to work at all...I have steering...The only time the motor will spin is when...
