New out of box. With power on I am getting a error code red and green light solid. Check input signal harness. I have done that and switched out the harness . Harness is good I checked continuity and it passed. I am stuck at this point . Any sugestions before I send back to novak .
Have you made sure the harness is not flipped backwards on the 3 pins of the esc? With the sensor plug and harness pins facing you, the far right pin of the harness should be the signal or white wire, middle is red, left is black.
Blacktiger355 wrote:Have you made sure the harness is not flipped backwards on the 3 pins of the esc? With the sensor plug and harness pins facing you, the far right pin of the harness should be the signal or white wire, middle is red, left is black.
I've made this mistake before, I was super frustrated, called the manufacturer and all - only to have the kid on the phone ask me about the order of the black/white/red wires on my receiver...
I was driving my buggy today and the esc seems to just die.
I was running a novak gtb 2 and all of the lights are off. Normally there are some status lights, even when something is wrong.
The the BEC is still providing power to the receiver and...
Last post
I declare this car haunted.
I swapped in a known good motor, new esc and new sensor cable.
It's cogging up a storm. I'll recheck all the connections and reset the esc and radio.
Should there be play when i mount my axel drive gears to the drive gear pivot after i install the button head screws or do i need to shim them so they are tighter? (approx step 42 in the original...
Last post
yeah i was wondering why there were no bearings where the felt was, seemed like it would be better with a bearing for reasons you stated... money pit!!!
***Is there a part number for those bearings or just use any in that size ?** (thanks for the...
Just saw these listed at RC Carbon works... they look like take offs of the old trackmaster transmissions.
I'm just unclear where the parts to complete them could be found? Like the belt, the stand offs/spacers, the correct diff, and...
Last post
Don't really know which was more appealing or desirable, just something different. I kinda assumed the direct drive was designed for more on-road and the belt for off-road, just a guess. I've seen them both ways. Trackmaster also made an oval...
I picked these up last week to experiment with. They didn't really cost much at all and they work :twisted:
I can program the Cyclone with my own custom parameters or use one of the 20 saved Novak sets to use as profile 4 on the Cyclone. Too bad I...
Last post
Wait, you have a computer with a serial port and diskette drive? :wink:
I'm a Mac guy in all honesty, but yes I do. I found it in the garbage and put XP on it :mrgreen: I use it mainly for the old school Toyota Electronic Parts Catalog Software...
with the weather getting nice i have been going thrue all my cars and matching up all the radios i have to a car
and checking that everything atill works
well was test driving my hot trick spint car when my dad (65) swings by
So I finally got to take my T4 out for a spin tonight. It has a Reedy brushless and ESC with a gens ace lipo. The first thing I noticed is that the thing is quiet and so smooth compared to my RC10. The other thing is that this thing jumps so...
Monday my wife and I went to see Ted at the Milford NH drive in. They had a small dirt track with a bunch of slashes for rent. You got 5 minutes for $3.00. Figured it was cheap enough so I went for it. It was a blast! They have the trucks tuned...
Last post
The wife really enjoyed it. If they enjoy Family Guy then the movie will be hilarious.
Was going to bring my SC10, but forgot and left it at home. I doubt they will let you throw your own on the track though, but the ones they provide are decent....