XX-4 restoration, road to the VONATS

[Mark Westerfield]

the Jconcepts b4.1 rear hexes will work perfectly. (jconcepts does not make the narrow rear buggy hex)

[pumpkinfish]

I measured the JConcepts part. It is .267" or 6.79mm. I added a .065" or 1.66mm washer between the hub and the pin, put the pin in then the JConcepts hex. Still looks narrow to me.

Body has been painted. Just need to take photos!

[pumpkinfish]

mark,

did you test out the belts? Are rollers needed? Also what tightness did you use?

[pumpkinfish]

Finally done and ready for tomorrow! Can't wait to race it. I will admit after all the work I did, I wouldn't mind shelfing it, but I bought it specifically to race at the VONATS.

[Incredible_Serious]

Neat.jpg (28.46 KiB) Viewed 790 times

Neat.jpg (28.46 KiB) Viewed 790 times

[slapshot1979]

Way to represent

clean build with a killer paint job!!

Can I ask why you run the inner holes on the inner steering arms? my thinking is that the inside tire would be at alot steeper angle when turning? I understand they make them with 2 holes on each arm to be setup differently but, Im just curious.