Hey everyone, I have my original RC10T that is literally like new. The body is missing and it drives my crazy not having one. I have found the "slammed" body that TBG has on eBay but I'd really like to have the original style so I can do a box art set up. Are there any reproduction original style bodies available?
Thanks for the above ebay link. Do you know if it is possible to find any new OEM RC10T bodies, and how to tell if they are the standard or the slimmer TEAM versions?
I'm looking to get a couple of Protech I bodies and wings sets to paint.
I only know of Boki and Team Blue Groove for reproductions bodies. As it appears only Boki has a Protech I Is one better than the other in terms of faithfulness to the...
Last post
I don't see it anymore, but Boki used to have a note in the description of the Protech bodies. It stated that they had adjusted the mold to correct some of the fitment issues with the original.
Maybe they have corrected it. The one that I did was...
I have a couple of new and uncut original Premier/Twister dirt oval wedge bodies, and after searching for more of the last 7 years or so, I haven't had much luck acquiring more. I have a feeling that the supply of NOS bodies out there is drying up....
Last post
an other one in French (sorry again, but I can translate if you like) mainly about building the vacuum box...
I'm currently building three Optima Mids simultaneously
1. Turbo Optima Mid SE with a few upgrades, replica of the buggy I bought new 20 years ago with the mods I couldn't afford but wanted to do back then
2. Turbo Optima Mid SP
3. Turbo Optima...
Last post
Unsure, but you will need an undertray for the zxr and the repros that are currently being made do not last long at all, kamtec have not made that undertray yet, but do the tomcat shell and is very good, better than the original.
I am toying with the idea of having some parts reproduced for some of the vintage Losi stuff. Molds will cost a fortune, I am sure. But might be enough interest from the people who want to run them and not just have them sit on a shelf.
So what...
Last post
that is the same problem i was having for the idler in the 6 gear transmission, $1000. or more just to make the injection mold
Anyone cutting reproduction chassis for 12i or 12e? I know reign is doing bumpers and shaker plates...I think we need someone to cut some woin chassis plates, possibly even undrilled for updating to newer and easier to source rear bulkheads.
Last post
I saw the blue and order a small sheet of 1/16, but i didnt see a 3/32 sheet- it went right to 1/8 which i thought was a bit too thick. I ended up with a couple sheets of 1/16 and 3/32
i know people say he re-pulls other peoples bodies and such, but most people that do reproduction bodies and decals, unless pulled from the original mold are basically infringing on copyrights in one way or another... which i personally dont care...