Title says it all, its a Ten 4, its going to be a runner
I'm building with spares from my runner not the most economical way to do it... Most parts are rere except the RPM arms
and the body post.
So far I am really pleased on how its coming together. I was surprised how strong the shapeways parts are, bending them on their sprues showed they are flexible. Tapping them out soon had my tap hot to the touch. I really like how snug the bearings are, I wish the 6565 stealth case in my runner was as snug. Perhaps somebody will do a 3d printed stealth case.
Care had to be taken to seat the bearings properly in the steering arms otherwise the axle would bind and not spin freely.
I also had to take the dremel out on the tub to clear the bellcranks properly. Problem which is present to some extent on most cars with original pre worlds bell-cranks.
Also had to cut the stealth case a little so the screw recess nearest the belt guide cleared better.
Still missing some bits: hinge pins; towers; Robinson gears and pulleys.
