Mr. Ed's Sawback 4LS "No rules applied"

[Mr. ED]

I like that! Nice paint job on it! Now all you need are some bigger tires like these.
...

Thanks. Painting on the outside makes masking and more complicated patterns quite a bit easier.

Larger tires... The thing is the body is very wide and covers the tires entirely. With the current tires I don't rub anything, even with the craziest flex. I can try some others I borrowed and put up the pic.
But no 2.2s for sure.

[Mr. ED]

I didn't have the chassis completely finished when I made this pic, but you get some idea of the flex.

[Mr. ED]

Axial Trepadors mounted

[Mr. ED]

Under the lid, a Mr. Ed's special mix

[SFC K]

Those look much better on there! It looks like you could widen the rear a bit and still keep them under the fenders. Nice battery tube holders as well for the dual saddle packs.

[Mr. ED]

Thanks. Those are drawer handles from the diy store, just like the stainless slider rails actually.

[Mr. ED]

I have to return those wheels and tires to my buddy.
But with the wheel wideners installed, the slightly smaller originals look a lot better now.
And to stop the excessive body roll and torque twist I made these:

DIY rear swaybar and...

front sway bar.

Field-test:

[Mr. ED]

PS: to thank my buddy I added some weight to his stock axial wheels.
Nearly 60gr in the fronts and about 45gr in the rears.

[SFC K]

Nice job on the sway bars and the wheel weights. Is that solder wrapped around the outside and inside?

The original wheels looks good with them widened.

[Mr. ED]

Thanks.
It's pure lead with an adhesive backing.
They sell this in arts and crafts stores. It's used for making fake glass in lead artwork.