After builded and assembed all RC10 of my dream, I will start the a strong new project, a 1993 Brian Kinwald World Champion Replica !
I started today by machining some special parts like the Brian's hand made.
This is a part of my NIB starting parts:
![Image](http://img512.imageshack.us/img512/1127/dscn0704ft1.jpg)
I start with assembling the ProLine 8105 XTR tires on wheels after machining this one like Brian (on picture one machined, the other stock):
![Image](http://img512.imageshack.us/img512/3244/dscn0706eg7.jpg)
I do the same with the ProLine 8086 XTR rear tires and machin also one wheel:
![Image](http://img519.imageshack.us/img519/3783/dscn0707vt5.jpg)
I machin the top face of the rear arms:
![Image](http://img519.imageshack.us/img519/4017/dscn0708nq5.jpg)
And I machin the lower rear edge of the rear Graphite Arms to do not stop the car with dirt:
![Image](http://img519.imageshack.us/img519/8763/dscn0709qm4.jpg)
I start to machin the right side of the rear bulkhead:
![Image](http://img519.imageshack.us/img519/6249/dscn0711om7.jpg)
And to finish today, I machin the rear top plate:
![Image](http://img519.imageshack.us/img519/8269/dscn0715fs7.jpg)
Next step looks to finish all this parts and start to machin chassis, nose plate and motor plate.
I search a rear white 1.5° NIB arm mount and a set of front NIB Graphite Arms, one Steering RCPS turnbuckle and eventually the batterie plate if this are not hand made !
Thanks for your help in this project, I try to give you some news at each important step !