Robb's Bolink Invader #2 & #3

The place for all things BoLink.

Moderators: scr8p, klavy69

User avatar
morrisey0
Super Member
Posts: 1836
Joined: Wed Jan 13, 2021 7:45 pm
Location: Richmond, VA
Has thanked: 95 times
Been thanked: 1886 times

Re: Robb's Bolink Invader #2 & #3

Post by morrisey0 »

My local Lowe's used to carry a lot of nylon bolts, but now seem to only sell slotted screws and nuts for those sizes. And they have 3-4 drawers of nylon spacers for some reason :?:
I build RCs like people would have done back in the '90s ..................................... if they had 3D printers.
Top
User avatar
morrisey0
Super Member
Posts: 1836
Joined: Wed Jan 13, 2021 7:45 pm
Location: Richmond, VA
Has thanked: 95 times
Been thanked: 1886 times

Re: Robb's Bolink Invader #2 & #3

Post by morrisey0 »

Got the electronics in the pan car this evening. The BEC and wire shortening made all the difference in the world in making this all fit under the body. Body posts and mounting will be the next step for #2.

INVADER 16.jpg
You do not have the required permissions to view the files attached to this post.
I build RCs like people would have done back in the '90s ..................................... if they had 3D printers.
Top
User avatar
morrisey0
Super Member
Posts: 1836
Joined: Wed Jan 13, 2021 7:45 pm
Location: Richmond, VA
Has thanked: 95 times
Been thanked: 1886 times

Re: Robb's Bolink Invader #2 & #3

Post by morrisey0 »

Finished up the MT mechanically today, just need to get the body on. Then both of them may sit as they are for weeks, or even months, for that rare day that I actually want to paint lexan bodies. :D

INVADER MT 10.jpg
INVADER MT 11.jpg
You do not have the required permissions to view the files attached to this post.
I build RCs like people would have done back in the '90s ..................................... if they had 3D printers.
Top
  • Similar Topics
    Replies
    Views
    Last post

Return to “BoLink Forum”