SilverTriple's printing and machining stuff...

[silvertriple]

The centering pin holes where until now guestimates based on my first try...
I did it more methodically this time...


Conclusion of the test with 4mm centering pins:
- 4.01 mm is perfect for the base : it enters but don't move
- 4.02 mm and the pin is sliding perfectly...
- anything more has more play... I could have do my uprights with more precision...

The precision is quite good and this will be used for any of the next parts...

[silvertriple]

The home fablab got slightly reorganized... This is close to my final target. One of the resin printer is still in this area but this is supposed to change at some point as it will go in the garage. It's currently not accessible, but the target is to get it installed in the garage.


The X1C and A1 Mini won't move anymore, but once the resin printer and wash station goes, I'll add some shelves for material storage...
Both Carvera Air and H2D have there definitive place. I'm targeting to install the AMS on the right of the printer. I've not bothered yet to install it correctly, as I intend to order a second AMS and 2 AMS HT to work with the H2D...
And my wife found some room for her hobby stuff as well...