FX-10 question....

[Brandon G]

What other vehicles wheels will swap with the FX10?

[highwayracer]

The FX-10 is pretty much a clone (with some differences) of a Tamiya Striker. So here are a few cars that use the same mounting system:

striker (1.7 wheel)
sonic fighter (1.7 wheel)
falcon (1.7 wheel)
grasshopper 2 (1.7 & 2.0 wheels)
super hornet (2.0 wheel)
fox (2.0 wheel)
wild one (2.0 wheel)

The 2.0 wheels are actually 2.0 for the rear and 2.1 for the fronts. They all use the 5mm x 11mm bearings in the front.

You can also use kyosho 2wd wheels as long as you use the hex adapter (on touring cars or the HPI adapter set). You'll have to use a 5mm x 8mm bearings for the front wheels.

hope this helps.

regards,
highwayracer

[Brandon G]

Helps very much, thankyou for the info!

[Mr. ED]

With the proper hex you can also go modern and use sand viper or desert gator wheels.

[Brandon G]

Actually I have the wheels to fit FX-10, just wondering what else they might fit.

[mrlexan]

Falcon, Fox, Wildone, Super Hornet, GH II..... anything with the 4 pin drive.