motor speed with voltage

Moderators: scr8p, klavy69

5 posts • Page 1 of 1

wiremonkey73: Approved Member; Posts: 42; Joined: Sun Mar 27, 2011 12:17 am

motor speed with voltage

Quote

Post by wiremonkey73 » Sat Apr 02, 2011 7:32 pm

my next question is does the rpms go up from runnin a 6 cell to a 7 cell. Also if so what is the rated speed of the motor as advertised at 7.2 volts

If you drive a prius you arent saving the enviroment!!!!!!!!!!!!

tamiyadan: Approved Member; Posts: 1683; Joined: Wed Apr 07, 2010 4:45 pm; Been thanked: 6 times

Re: motor speed with voltage

Quote

Post by tamiyadan » Sun Apr 03, 2011 3:43 am

wiremonkey73: Approved Member; Posts: 42; Joined: Sun Mar 27, 2011 12:17 am

Re: motor speed with voltage

Quote

Post by wiremonkey73 » Sun Apr 03, 2011 5:01 am

There needs to be a standardized system for this.

If you drive a prius you arent saving the enviroment!!!!!!!!!!!!

tamiyadan: Approved Member; Posts: 1683; Joined: Wed Apr 07, 2010 4:45 pm; Been thanked: 6 times

Re: motor speed with voltage

Quote

Post by tamiyadan » Sun Apr 03, 2011 11:11 am

wiremonkey73: Approved Member; Posts: 42; Joined: Sun Mar 27, 2011 12:17 am

Re: motor speed with voltage

Quote

Post by wiremonkey73 » Sun Apr 03, 2011 5:06 pm

Well Im not racing it just a parking lot and back yard toy is all it is. Unless you count backyard racing aginst my little brother.

If you drive a prius you arent saving the enviroment!!!!!!!!!!!!

Post Reply

5 posts • Page 1 of 1

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Sign in

Similar Topics

Replies

Views

Last post

Le Mans motor voltage question

Last post by Mad Racer « Sat Oct 23, 2010 7:06 pm
Posted in Kyosho Forum
Replies: 7
by Coelacanth » Mon Oct 18, 2010 7:25 pm » in Kyosho Forum

First post

I was looking over that image of all the Le Mans motors, in particular the rated voltage for each one, and was wondering what physically enables a motor like the 360 Gold for instance to use up to 8.4V but not the 480 Gold? Construction-wise, both...

Last post

You are right. I really think that info is not right.

Really any motor should handel 8.4v more so the Alloy end bells ones.

Too me the strongest motor i think is the 240SB the spa motors were no better as i raced them all.

All of the Kyosho...

7 Replies

2981 Views

Last post by Mad Racer
Sat Oct 23, 2010 7:06 pm
Motor voltage not reaching 7.2V. Vintage setup. Car slow.

Last post by Bakauata « Thu Feb 06, 2020 11:55 am
Posted in Vintage Electronics
Replies: 14
by Bakauata » Sun Feb 02, 2020 8:18 pm » in Vintage Electronics

First post

I've felt, from the first time I ran it, that the RC10 I put together last year (seemed very slow compared to videos I've seen of vintage cars running.
I've never had an electric before, so really didn't know what to realistic expect, and had...

Last post

Thanks. There was a Kyosho Rampage gp 10 in the lot, but the hub mounts are different.
I’ll put them aside for now.

14 Replies

3260 Views

Last post by Bakauata
Thu Feb 06, 2020 11:55 am
Kyosho K-Speed motor, any good?

Last post by Coelacanth « Tue Jul 31, 2012 2:45 pm
Posted in Kyosho Forum
Replies: 1
by sheriff » Tue Jul 31, 2012 2:18 pm » in Kyosho Forum

First post

Thinking of getting a couple of these, one for my Ultima ST, and one for Optima, perhaps.

Anyone got one one, any good? They're a good price, I know that.

Cheers!

Last post

I'm not too familiar with it, but a bit of research seems to indicate it's for monster trucks and is a 22T motor, so it's not something well-suited for an Optima. It may also spin in reverse, as monster trucks may be setup to run 2 motors, one in...

1 Replies

631 Views

Last post by Coelacanth
Tue Jul 31, 2012 2:45 pm
Capacitors? New motor, old speed control

Last post by Bormac « Wed Dec 16, 2009 12:08 am
Posted in Modern Electronics
Replies: 5
by MelvinsArmy » Tue Dec 15, 2009 9:11 pm » in Modern Electronics

First post

So, it's been a long, long time since I've had to deal with capacitors. I'm wondering if I need some now. I'm trying to get my RC10 truck conversion up and running. It's got a new Reedy StockStar motor in it:

Which, according to the AE site says...

Last post

I recently tried getting all nostalgic and set an old techniplus acoms radio in one of my beach scorpions. The car got about 5 feet away then started going C R A Z Y ! The antennae wire was plenty long enough and everything was wired in right....

5 Replies

651 Views

Last post by Bormac
Wed Dec 16, 2009 12:08 am
Motor set up top speed

Last post by SWAZ RC « Fri May 24, 2013 12:49 am
Posted in Vintage Electronics

by SWAZ RC » Fri May 24, 2013 12:49 am » in Vintage Electronics

I found my cobalt 12T motor for my voggard T10 on road project. I want to get the most out of it top speed with out going lipo. Can I get some info on what would be a good esc and battery combo to go 45mph or more. I was thinking of a novak T4 and a...

0 Replies

721 Views

Last post by SWAZ RC
Fri May 24, 2013 12:49 am
Speed Passion Motor Wires

Last post by yellowdatsun « Fri Sep 16, 2016 2:07 pm
Posted in Modern Electronics
Replies: 5
by Tamlok » Tue Sep 13, 2016 7:33 pm » in Modern Electronics

First post

Just picked up a Speed Passion Reventon S, but the motor wires are too short. Does anyone know if I can remove the old ones at the ESC? This model has the wires pre-soldered from the factory on the board, unlike the Pro which has terminals. I really...

Last post

I don't use anything less than 60w. It's a good compromise, and hot enough to do all your RC stuff. A 40W iron likely wouldn't cut it.

5 Replies

1003 Views

Last post by yellowdatsun
Fri Sep 16, 2016 2:07 pm
Top speed motor and lipo

Last post by Coelacanth « Tue Nov 26, 2013 11:14 am
Posted in Modern Electronics
Replies: 7
by fastang » Sun Nov 24, 2013 6:12 pm » in Modern Electronics

First post

A friend and I started building a car for top speed runs. While researching esc's I noticed most of them have a 3.5 limit on motors using 2s or 6.5 limit if using 4s.

My question is if everything else is the same (gearing, tire size, etc) would a...

Last post

Regardless of gearing, horsepower as it relates to electric RC cars is a function of motor & battery. How much power you create is dependent on motor & battery. The most powerful motor will be a gutless wonder with insufficient voltage pumped into...

7 Replies

1221 Views

Last post by Coelacanth
Tue Nov 26, 2013 11:14 am
Trinity Speed Gems Motor help?

Last post by nvxwax « Wed Jul 07, 2010 7:17 am
Posted in Vintage Electronics
Replies: 6
by nvxwax » Tue Jul 06, 2010 8:33 pm » in Vintage Electronics

First post

Anybody ever had a motor like this? I have done some searching and could not find anything about it, It looks to have the name spelled wrong?

It has Speed Gems Chrominum on the can lable

I know Trinity made Speed Gem motor but can find a reference...

Last post

I forgot to add, I have a Chrominum too. Probably belongs on engrish.com.

LOL, thats pretty good

6 Replies

702 Views

Last post by nvxwax
Wed Jul 07, 2010 7:17 am

Return to “Vintage Electronics”

Who is online

Users browsing this forum: No registered users and 9 guests