rc10t part # help.

[Volumiza]

hi, i wonder if anyone can help, i need the part number for the BLACK rc10t nose tubes, they're not produced anymore but i'm in need of a pair. i've had a snoop on the associated site but i cant D/L the manuals for free

or if anyone has a set i can exchange for some money, even better

[mikedealer]

http://www.teamassociated.com/shusting/CatalogHub/cathub_offroad_1.10truck.htm

Part # 7315, im looking for them now

[RC Chick]

Do they need to be new??

[tulsa]

here they are http://cgi.ebay.com/Team-Associated-Nose-Brace-Tubes-Part-7315_W0QQitemZ260085020145QQihZ016QQcategoryZ44028QQrdZ1QQssPageNameZWD1VQQcmdZViewItem

[mikedealer]

those are blue.. but the part number is the same..they just replaced the blue with the black at some point like they did with alot of parts

[templeofspeed]

Two products...

EZ-off

and

Sharpie-pen



If the AE blue on the current tubes is anything like the FT turnbuckles on my B44 it'll just fall off by showing the EZ-off can to them...

[terry.sc]

You should be able to download all their manuals from here
http://www.rc10.com/shusting/CatalogHub/cathub_offroad.htm

[hkp]

Vols, if you want to grab 2 pairs and save on shipping, let me know and I'll have a pair.

Tom

[Volumiza]

Do they need to be new??

they dont need to be new RC Chick but they need to be in pretty good condition as they're for my A&L and my A&L is my darling and i'm too close to finishing it to start compromising now. if push comes to shove then maybe i could get some FT blue ones and get them reanodised?!?

thanks for all the replies lady and gentleman

[Volumiza]

Vols, if you want to grab 2 pairs and save on shipping, let me know and I'll have a pair.

Tom

if i go down that route tom then i'll PM you before i do

[RC Chick]

sorry Vols, I just looked at the extra ones I had and I'm sure they won't be good for your pretty AL car. They were scratched up, one was bad in one spot. I was at the hobby store yesterday, I even asked them but they only had the RC10 in black in stock.

[Volumiza]

no worries rc chick, i appreciate people even looking

[scr8p]

just get blue ones, strip them, and paint them with a satin black.

[Volumiza]

just get blue ones, strip them, and paint them with a satin black.

i think i may have to do something like that while i keep my eyes peeled for some bona fide black 'uns

[mikedealer]

call a local plating place. sometimes they do runs of stuff and it doesnt cost them jack to throw in some extra stuff. you may wait a while but its worth it if they dont charge you what they would normally charge. i wanted some parts for my b4 anodized a while ago with red anodizing, it took a month but they did do it and called me the day it was done and charged me like $25 bucks or something. i had some stuff powdercoated from them in the past for my trans-am and they were glad to help me