Compatible Custom Works Pins

Post by **mrlexan** » Sat Jan 04, 2014 9:40 am

Anyone know another manufacture that carries the same hinge pin dia as Custom Works? AE and Losi are too big. The CW pins have been on back order for a long while and I am missing a couple. I've got tons of loose pins, but haven't been able to find a matching diameter. I searched the forum and didn't see it asked or discussed.

Thanks.

Jay

Post by **jwscab** » Sat Jan 04, 2014 12:00 pm

3mm pins are smaller than 1/8" so maybe a metric car like hpi or something?. Also later associated b4 t4 etc use a smaller pin. 7/64" or something like that. No groove for e-clips though.

If you can get dimensions and its a standard drill blank size I can make some for you.

Post by **Charlie don't surf** » Sat Jan 04, 2014 12:11 pm

Yokomo- I have tons of loose Dominator pins too Jay-

Post by **mrlexan** » Mon Jan 06, 2014 7:47 am

Thanks guys, I'll check my stash of Yokie pins.

RC10Talk - The Net's Largest Vintage R/C Community