Nix 91 stealth build

[dj_kilroy]

Hey Guys,

Here's a few pics of my Nix 91 stealth build so far.

[Minisforever]

Wow, that yellow really pops against the black! Looking good

[GoMachV]

Yup! Love the yellow. I bet jake would do carbon towers if you ask him nicely

[dj_kilroy]

Yup! Love the yellow. I bet jake would do carbon towers if you ask him nicely

Thanks, I wasn't sure if people would like it, but I think it looks good. It will really stand out racing against modern 2wd's that all have a similar look.
Yeah, I'd love carbon towers to mount big bore shocks with holes to mount kyosho wing mounts. Hint, hint.

[Niki]

SLS parts were dyed by Shapeways? Do I remember right?
Parts look OK?

-Niki-

[edwin pibal]

Man, that looks cool!!!!

Ed

[dj_kilroy]

SLS parts were dyed by Shapeways? Do I remember right?
Parts look OK?

-Niki-

Yep, I ordered them in yellow. They must use the same RIT dye that I have as its a perfect match. The only problem is that I'm going to have to grind the front and rear arms for clearance reasons and will have to re-dye them.

[Niki]

Is it possible dye color is so deep in part it doesn't go white even you grind it?
I've seen SLS parts painted with acrylic hobby paint and will in most cases color entire part volume.
Does it make sense to offer dyed parts through Shapeways? How do you see it? Or only black and white?

-Niki-

[dj_kilroy]

Is it possible dye color is so deep in part it doesn't go white even you grind it?
I've seen SLS parts painted with acrylic hobby paint and will in most cases color entire part volume.
Does it make sense to offer dyed parts through Shapeways? How do you see it? Or only black and white?

-Niki-

When I ordered the parts, I thought they would print them in colored plastic. If I had of known, I would of dyed them myself as I think it cost more for the color.
The dye isn't that deep in the material, so I will definitely re- dye them. I may have to use black tho, as they may go too dark if dyed again in yellow.

[Niki]

How about those black bellcrank parts? Black SLS print material is available - did Shapeways use it or dye to make parts black?

...after reseaching Shapeways pages I think black is dyed also

[GoMachV]

It looks great, but I think if it's just dyed it would be easier to just make em all plain white. I thought the printed material was colored....well, until a week ago

[Minisforever]

Might be over the top, but they make a carbon/Kevlar weave the is black and yellow. Transmission brace? Motor guard? Might look cool with that look

[Mark Westerfield]

Is that a BJ4?

[Minisforever]

Atomic s4