Dirt Oval Runner

[LTO_Dave]

I thought about putting this in the re-re section because all the plastics are new, but the TPS and bottom-loaders with notched-pistons made me keep it here.

I'm planning to run this next season at my local dirt oval, and possibly the rest of this season if I can finish it. I still have to buy modern electronics and will be sending the body out for custom paint since I suck at it.

- TPS chain-drive tranny
- McAllister lowering kit
- MIP 3/16" CVD's (Thanks Jeff Malar!)
- Tecna 6-40 tie-rods with RPM cups
- Andy's bumper/body mounts
- CW Bullet Wedge

[Fred19K]

That is very clean looking; very well done. Please post pictures of it finished.

[DaveM]

Hi Dave,

Looks too nice to run!

Cheers, Dave.

[NCOHOG]

Well that looks familiar!

[knucklebuster]

Nice score LTO! That was my first choice but NCOHOG has another on my wish list...

[knucklebuster]

I can't believe you didn't pick up a Bat Wedge!!!

[LTO_Dave]

I can't believe you didn't pick up a Bat Wedge!!!

I have an NIP Premier Designs Bat Wedge that's for another project. I thought about picking up a TBG repop, but I try not to support him and use original bodies.

I have a CW Bloomquist Wedge that I'll probably spray bomb and use for practice laps.

I already have the paint design sketched and a painter on the East Coast willing to do the airbrushing. I won't post any pics until I have the Bullet mounted on the car just to keep everyone in suspense.

[THEYTOOKMYTHUMB]

Yet another beauty!

[askbob]

Looks killer! Look forward to seeing the body.