I will have a Parma Euro Panther project through the winter. Not restoring an old car but building a car from parts, again.
Got a prototype chassis and some special parts but there are lots of missing parts also. Have an exploded view drawing but dimensions and part # are unknown. Someone have a manual, if there was one?
Some questions on hardware, what size/type are screws and nuts used for front end and t-bar?
Also what size is the brass (?) ball used at the ballcup for the center dampener, the one which uses silicon tubing. Have that dampener but the ball is missing.
Parma Euro Panther project
-
- Similar Topics
- Replies
- Views
- Last post
-
- 64 Replies
- 9099 Views
-
Last post by TomiS
-
- 5 Replies
- 1334 Views
-
Last post by karnivool
-
- 5 Replies
- 1084 Views
-
Last post by Charlie don't surf
-
- 14 Replies
- 5279 Views
-
Last post by littleVETTE
-
- 12 Replies
- 2729 Views
-
Last post by isobarik
-
- 6 Replies
- 1503 Views
-
Last post by Bullfrog
-
- 3 Replies
- 1676 Views
-
Last post by clinehobbies
-
- 17 Replies
- 3589 Views
-
Last post by spru
Who is online
Users browsing this forum: CommonCrawl [Bot] and 7 guests