Page 1 of 1
Hardcase lipo fitment
Posted: Sun Jun 16, 2024 6:09 pm
by bigmd
What’s everyone using as a battery hold down? Just got my 2s hard case and while it fits the bulkhead just fine , the battery hold down won’t work. I suppose i can use some washers to gain clearance. Is there any other solution? I’m excited to get this thing going. Just got my vintage Novak gear mounted.
Re: Hardcase lipo fitment
Posted: Sun Jun 16, 2024 10:25 pm
by JosephS
bigmd wrote: ↑Sun Jun 16, 2024 6:09 pm
What’s everyone using as a battery hold down? Just got my 2s hard case and while it fits the bulkhead just fine , the battery hold down won’t work. I suppose i can use some washers to gain clearance. Is there any other solution? I’m excited to get this thing going. Just got my vintage Novak gear mounted.
I use either thumb nuts with studs
or just longer screws for the battery hold down.
Re: Hardcase lipo fitment
Posted: Mon Jun 17, 2024 4:40 am
by bigmd
Thanks for the reply. After I read your response I realized I’m an idiot and there was no need for a different hold down. All I had to do was loosen the screws a bit. It all fits . Thanks