Hardcase lipo fitment

Post by **bigmd** » Sun Jun 16, 2024 6:09 pm

What’s everyone using as a battery hold down? Just got my 2s hard case and while it fits the bulkhead just fine , the battery hold down won’t work. I suppose i can use some washers to gain clearance. Is there any other solution? I’m excited to get this thing going. Just got my vintage Novak gear mounted.

Post by **JosephS** » Sun Jun 16, 2024 10:25 pm

bigmd wrote: ↑Sun Jun 16, 2024 6:09 pm What’s everyone using as a battery hold down? Just got my 2s hard case and while it fits the bulkhead just fine , the battery hold down won’t work. I suppose i can use some washers to gain clearance. Is there any other solution? I’m excited to get this thing going. Just got my vintage Novak gear mounted.

I use either thumb nuts with studs

or just longer screws for the battery hold down.

Post by **bigmd** » Mon Jun 17, 2024 4:40 am

Thanks for the reply. After I read your response I realized I’m an idiot and there was no need for a different hold down. All I had to do was loosen the screws a bit. It all fits . Thanks

RC10Talk - The Net's Largest Vintage R/C Community