Hi everyone, can anyone tell me what is this chassis? I've never seen it anywhere, it is blue anodized and milled everywhere, even under the tranny, the two rear holes that receive the screws attached to the motor plate are also milled... anyone?
_____________________________________________
_____________________________________________
Come and visit the stable
I've had this chassis safely tucked away for well over ten years. My plan was always to find a matching nose plate and build a shelf queen with it. Today I was comparing it to all of my other RC10 parts and ... well ... what is it? :lol:
Blue...
Last post
I have black nose tubes and a black Litespeed Litesink for the build. I'm not so sure about using a black nose plate though...
Hey guys I have seen a few post where the Question of blue screws come up. I see tower has blue screw kits for the rc10 and rc10t listed and are due late august. Part numbers are.
LX3326 for the RC10
LX3325 for the RC10T
Last post
All I can say to that is the boat from china takes time. :roll:
Did associated ever make a .71 shock in blue anodized. I would like to know so that if they didn't I wont waste my time hunting for them.
Last post
If by 4) RC Carbon Works front tower ( with the mulltiple shock mount locations)
you are referring to some thing like their Associated RC 10 Extended World's Front Shock Tower 3MM RACERS EDITION :
This project started with a new partially assembled RC10B4. This could be the stealthiest RC10 of all time. Except for the shocks, this is as blacked out as a buggy can be!
I came across blue anodized suspension arms for the B4 (not sure who the...
Last post
Thank you for the suggestions. I have been very lucky with this project. I have an Avante MK2 and realized that the Tamiya shocks were the same length as the B4, and the color matched the color of the suspension arms! The plastic associated ball...
This is my other aluminum buggy build I have been working on over the last few months. As you can tell I am a sucker for the aluminum bling, not the best on the track but it sure does look good. :)
Re Re chassis and nose plate striped and anodized...
Last post
This color combo and metal parts build is outstanding.
It's ugly. Very ugly. But i think I'm onto something. this is the first time I've got it to work. The color is pretty close to the original gold but completely flat. I think i need to do a better job of preparing the metal after I strip the original...
Last post
> -Did the RC10 get the RC from Roger Curtis or Radio Controlled? Does Gene want a car/edition named after him? GH10 perhaps? What about A CL10 for Cliff Lett? Does your dad and Cliff still talk? This leads to the following-
>...
Hi All,
I searched the forum first so if I missed it, please post the link...
I am rebuilding an original RC10 and building a B6 (going for a retro look). I would like to get both anodized in the original Associated gold. Where might I be able to...
Last post
I used oven cleaner in the past to remove existing anodizing but this was years ago, I'm not sure if the cleaners are the same as they were back then..
You want the yellow can. Real Easy-Off seems better than the off brands but definitely has a...