RPM worlds Rear end question

[JK Racing]

As I plan to race my RC10 with the worlds front/rear conversion kit, the main part I am seriously concerned about are the rear arm mounts. If I bust one, without having some spare vintage parts on hand, what would I use to replace them? RC10GT? B2/T2? B3/T3? SOL?

What are the thoughts out there?

[scr8p]

you'll have to replace it with another worlds arm mount. so, i'd be on the lookout for some spares.

[JK Racing]

I have been spying on some, was just hoping there were other options out there.

[highwayracer]

One more thinkg to keep in mind...I think the RPM mounts also come in different degrees (for rear toe in). So, if you break a -1, you need to replace it with a -1, or replace both if you don't have a match.

Regards,
highwayracer

[Asso_man!]

Yeah, they have produced 1.5 and 3.0 degrees. I think it's even written on them, but not so sure...

[JK Racing]

The set I've been looking at has both 1 & 3, I figure I would get a couple set of different toe in rear hubs to compensate....