★Clean up your motor commutators with these brushes - around 2 or 3 minutes with battery pack connected will freshen up brushed motor performance. ★Contains two cleaning brushes.
Does anyone have experience with these? I'm not sure how these would work more than once.
Does anyone still make comm sticks? I’ve only seen them for high prices with shipping included. These seem to be about 12$ shipped.
Is a fiberglass pen about the same as a com stick?
I don't know much about it but it looks like a stock motor lathe. Does anyone know the model, or have a link to instructions on this lathe or type of lathe?
Is there...
Last post
A lot of motors have spring posts that are not removable. They basically are a rivet style attachment. The earlier stock motors were not intended to be disassembled for rebuilding, so many have permanently installed spring posts. The one on the...
I thought I'd start with something easy for my first attempt with an air brush. The Dyna Storm was perfect for the job!
I used liquid mask and Faskolor water based paint. The air brush was used for the liquid mask. It took about four good coats to...
Last post
I just used an inexpensive $30 dollar Central Pneumatic airbrush. I didn't want to invest in an expensive brush and compressor until I figured out what I was doing. It's perfect for basic solid-color paint schemes.
That is my suggestion too. I got...
I am looking for a decent primary paint kit...kind of like the old Testors kit but more oriented towards clear lexan. The bodies just keep stacking up on me. When I work on a kit I do everything except for the bodies :roll: Really need to get...
This is the only slot brush conversion MG motor i have ever come across, sourced from an ex-MG and Yokomo team driver Ian Oddie. It has some beautiful endbell detailing, as per the occasional Trinity slot conversions, and the Sagami lettering on the...
Last post
At one point it was pretty much Sagami (for Yokomo) and Tokyo Mechs (trinity) as rc car motor base component manufacturers from what I understand. There had to be some others but those were the two top companies. I'm not sure where Air Supply (CAM,...
Just bought this XiPP comm lathe, along with a brush cutter attached to a Joel Jonhson Motor, the deal even included a hard case and a Trinity P2K2. I think I got a heckuva deal for $25. Time to start cutting comes and brushes.