RC10 ball bearing steering???

[Motor'n]

I have been in the process of building a few new runner RC10's and restoring a few more. I really have a hard time finding the steering bell cranks for the tubs. I occasionally see them on E-bay but I always seem to get out bid... Is there another company that makes these or a parts list of new components that will work? any help in greatly appreciated.

[rctenracer]

http://www.rc10talk.com/viewtopic.php?f=38&t=8782 .
This may help you out. Not much out there as far as new stuff. The wanted scetion or ebay is your best bet for parts . You can pick up the parts in the post from tower . The bearings from avid. I used this set up after I saw the post. Cost around fifteen bucks for parts and shipping and took me about a hour to assemble.

[Motor'n]

I was looking for something a little more period correct for the vintage builds. I think this would work well for the modern updated runner. What servo mounts are you using for this configuration?

[PBR Allstar]

if you want something a little different then look at what is getting used on any of the terminator based dirt oval cars. Kranzel's, JRC, GFRP, Putnam, all make an offering that will work on an RC10

[Motor'n]

Do yo have any links to these companies?

[AscotConversion]

www.dirtoval.com