RC10Talk - The Net's Largest Vintage R/C Community

20230909_185740.jpg 33 Ford on a carbon chassis. Savox SC-0251mg servo and a Intellispeed mild-mod ESC. Velcro body and grill mounts. Axial 20T motor for easy street runs on soft foams. Aluminum rear axle and hubs that are spaced for stance. Original brass bushings in the rear. Full bearings up fro...

Also a donation maybe?

Thanks guys! Heading out to the race this morning, so I figured I'd get the pre-battle pics up. I don't know what happened to a few of them (not centered), but didn't have time to retake them the other day. 20230906_081638.jpg 20230906_081708.jpg 20230906_081729.jpg 20230906_081747.jpg 20230906_0818...

https://www.rc10talk.com/viewtopic.php?t=47752
. .

THEYTOOKMYTHUMB wrote: ↑Fri Sep 08, 2023 10:54 pm Got this from my cousins the other day.

Humm?

RC10B4. Now has a B4.2 body on it also installed a esc shelf and a gear diff.

I think this one is done (maybe ). Finished it off with some minimal bodywork, Novak Cyclone ESC and XXTRA receiver.
. . . .

Think I'd just buy an M4 die and cut the thread myself .

Sitting on my friends patio the other day and this happened, what I'm calling a horizon rainbow because it was flat across the horizon, not the traditional arch that rainbows usually are. Pix were taken about 10 minutes apart.
.

I think the thread pitch is .70 . My tap and die set doesn't go down to M4 and the cost of the axles compared to a M4 die is about the same price so I just got the axles.

Got myself a race truck from eBay.... a nice T3. Should be great for the Vintage Bash in November.... even if I can't drive!

Well, it's tranny Tuesday. :D I have the parts sorted and will start opening everything up if my ocd can lay low for a while. I won't be using the Thorp Stealth slipper top shaft, but I will set it to the side in case I ever decide to swap out the Hydra. It appears that particular 3101 Hydra kit is ...

Here is the boki turbo mirage body.

Today was shock tower day. Opening the bags was somewhat stressful since I had never seen the rear tower in the wild. I drilled two upper holes for the rear tower to mount properly to the RPM rear bulkhead. The front bolted up as expected. I'll most likely use 3/4 shcs for the upper & lower shoc...

Finally got some done on the graphite tub.
A&L steering rack with some Composite Craft Teflon tape underneath and the mighty Schumacher SACS active caster system U1617A for the RC10