Latest updates. Both run well. Very different from any of the Tamiya kits I've built or restored.
Top is the protech body, bottom is the protector body from what I remember. Top has undyed hardware bottom has the hardware that was dyed yellow by a previous owner.
I've been out of the hobby since the 90s. I picked a pretty decent RC10 CE that I want to restore and upgrade a little. I think I found all the stealth transmission parts but I can't track down the original stealth transmission slipper...
Last post
Cheaper to wait for a whole stealth to pop up on ebay, they go for about $75 and you get everything. :D
Hello, my name is Cameron. I posted the following on Ripper7Racing; acerpower sent me here for help. This is my first experience with non-Tamiya vintage stuff (I've spent a ton of time on tamiyaclub.com drooling over Shodog's showroom). I currently...
Last post
Part IV: Electronics
With the threat of finals week looming overhead, I didn’t get much done this past weekend as I would’ve liked, but I guess I’m keeping a fairly constant snail-esque pace. I wasn’t expecting any new parts this week, and I...
I just finished up one of my current resto's. I started with a mint A chassis and some new tires.I used the speed control I recieved from scr8p I just had to find new wiring the soldering job isn't the best I need a hotter iron. I dyed most of the...
Last post
No they were a set of good used white ones I had . The only parts I didn,t dye are the battery cups and rear a arms those came from tower. All the other parts were either nip (trans case) or good used parts no slop, cracks, stripped out holes ect....
Hi guys new to the site hi. I have just purchased a rc10 t after always wanting one
So the one I have looks In good condition the plastics are yellow I plan to whiten these ( any reccomendations are welcome ) and to powder coat the tub .
Also I...
Last post
Hey thanks for the info will the gt diff rebuild kit service the 10 t also
Will a set of replacement diff out drives fit the 10 t as I'm wanting some
For the build the truck is coming along nicely have had the pan powder coated
And whitened the...
I recently bought one of my best friend's RC10 from him as I had gotten a kick to restore RC's lately - I had only seen the car once when I was out at his parents place WAY back in the day and knew what it was but didn't care much as I was into on...
Last post
Bringing this back up! Decided to take this from a shelfer to a racer! Going to be a few changes -
Swapped original rear tower back on for the extra top shock hole
Dynamite modern brushed ESC
Hitec HS645MG servo
Spektrum SR300 receiver
Jconcepts...
This is my dads original rc-10. He tried getting it runing this past summer but found that it didn't perform as it used to. the slight flat spots on the tires and lack of oil in the shocks certainly contributed to that.
I swiped the car from him...
Last post
Cudos to anyone who can spot the problem parts before Scr8p does.
Guys, lay off Anthony, it's family heirloom.
hey....... he asked for it. :wink:
Hello all, you have inspired me and I recently won this DS
I am looking foward to recieving it and also for any help, tips or pointers you may have in the reconditioning and restoration. For those that dont want to link to the bay I have attached a...
Last post
Hey did you get the radio problem fixed if so what was the problem?