On a related topic, you're friends with Dan from carbon works right? Think there's any chance he'd do worlds style shock towers, but for B4 length shocks?
Was only supposed to pick up a couple parts then I spotted it :shock: and well...You all know how it ends :) :) When I am ready to tear it apart and clean it up I will be asking a lot of questions...So be ready...First question will be how to clean...
Last post
8) 8) Had no idea that the shock tool would work...My fingers will be happy , happy , happy :)
It took me longer to build the theater than it took to build the house.
130+ screen, 7.1, 2k watts, sub plays well below 20hz and lots of acoustic damping.
The only task that was farmed out was the seating upholstery.
It started as an unfinished...
Last post
Doug
Once again too kind... Thank you.
You might even have appreciated the fact that I modeled it first in Sketchup :shock:
But not even close to the ability you have shown for nearly photo-realistic renderings on some of your projects.
Here are a few shots of a three week project from 1992 or so.....
Last post
Well, I have been out for a while due to end of semester reports and what-not. But here I am back and what a treat. That truck is super nice. Off to see what else I've missed.
Hah, I'm still such a kid. But I figure what good is it to have shelfers sitting downstairs by my workbench when I can have them on the table while I do my work?
What kind of solutions are necessary to do anodizing and get all those cool colors? AND where do I get them without being in the industry? I remember RC CAR doing a home brew anodizing article like 20 years ago, using dry cells or lantern batteries,...
Last post
This guy is less than Caswell Plating and he's a fellow Pennsylvanian too.