RC10Talk - The Net's Largest Vintage R/C Community

What do the kids say, I'd tap that? Who knew they are all into metal work.
.

This seemed like a cool little gadget. It continuously scans the frequency range and marks what it finds.
.

Cool Sunrise this morning.

The car went 85mph in 1.7 sec in that video with a small 13lb thrust composite rocket engine....2 days prior I ran a 23lb engine for 1.4 seconds....thing was ballistic but I didn't get a start on my GNSS some didn't get a read....got lots of new engines I will be testing in the near future...stay tu...

Here’s my woin xls runner.


Build thread with more pics can been seen here

https://www.rc10talk.com/viewtopic.php?t=47808

2018 https://scontent-iad3-1.xx.fbcdn.net/v/t1.6435-9/45787785_10156862626850842_599510948427857920_n.jpg?_nc_cat=102&ccb=1-7&_nc_sid=730e14&_nc_ohc=DAc-CAVFzBYAX9XrPnQ&_nc_ht=scontent-iad3-1.xx&oh=00_AfDQq8n9y7EpHZxW1Hlm--4m9RDwEX9wzJ8T1sPDpO3oDw&oe=652046D5 Last catalog is ...

Early RC10

Old build thread https://www.rc10talk.com/viewtopic.php?t=25230&hilit=early+RC10+resto

IMG_2961.jpeg This is my 2016 Chris Van Air rc10t reproduction. This is based off the rc10t that won a nonvintage race in 2016 at Hot Rod Hobbies. Chris was kind enough to help me nail all the details and Jeremy from ‘off the grid ‘ rc paint made me an exact copy of the design he did for Chris. Her...

20230909_185740.jpg 33 Ford on a carbon chassis. Savox SC-0251mg servo and a Intellispeed mild-mod ESC. Velcro body and grill mounts. Axial 20T motor for easy street runs on soft foams. Aluminum rear axle and hubs that are spaced for stance. Original brass bushings in the rear. Full bearings up fro...

https://www.rc10talk.com/viewtopic.php?t=47752
. .

RC10B4. Now has a B4.2 body on it also installed a esc shelf and a gear diff.

1901 TRX-T. Had it on layaway at the LHS. Put my Blackfoot on the hobby shop "resale lot". That and lawn mowing money.....anyway.

Built, never run, Traxxas Eagle. One little mark on the top of the chassis, and a couple of flat tires. Protective clear cover on the bottom

Novak Electronics was founded by Bob Novak out of his home garage in Santa Ana, CA. in 1978. After graduating from Iowa State University with a degree in Electrical Engineering in 1968, Bob, an R/C airplane enthusiast from Omaha, NE. began working at CTS Knights of Sandwich, IL. a position that woul...