Latest updates. Both run well. Very different from any of the Tamiya kits I've built or restored.
Top is the protech body, bottom is the protector body from what I remember. Top has undyed hardware bottom has the hardware that was dyed yellow by a previous owner.
I just finished up one of my current resto's. I started with a mint A chassis and some new tires.I used the speed control I recieved from scr8p I just had to find new wiring the soldering job isn't the best I need a hotter iron. I dyed most of the...
Last post
No they were a set of good used white ones I had . The only parts I didn,t dye are the battery cups and rear a arms those came from tower. All the other parts were either nip (trans case) or good used parts no slop, cracks, stripped out holes ect....
Hello, my name is Cameron. I posted the following on Ripper7Racing; acerpower sent me here for help. This is my first experience with non-Tamiya vintage stuff (I've spent a ton of time on tamiyaclub.com drooling over Shodog's showroom). I currently...
Last post
Part IV: Electronics
With the threat of finals week looming overhead, I didn’t get much done this past weekend as I would’ve liked, but I guess I’m keeping a fairly constant snail-esque pace. I wasn’t expecting any new parts this week, and I...
I've been out of the hobby since the 90s. I picked a pretty decent RC10 CE that I want to restore and upgrade a little. I think I found all the stealth transmission parts but I can't track down the original stealth transmission slipper...
Last post
Cheaper to wait for a whole stealth to pop up on ebay, they go for about $75 and you get everything. :D
im restoring my rc10 gold pan with rpm arms and was wondering what wheels fit the car? i want to put mip cvds on it can i use stock carriers with those? Also with the rpm arms being longer what size turn buckles do i use? finally what size shocks do...
Last post
Or you could get a set of wheels that are 2.2 and not change anything else. I have bought a few of these:
Hi guys new to the site hi. I have just purchased a rc10 t after always wanting one
So the one I have looks In good condition the plastics are yellow I plan to whiten these ( any reccomendations are welcome ) and to powder coat the tub .
Also I...
Last post
Hey thanks for the info will the gt diff rebuild kit service the 10 t also
Will a set of replacement diff out drives fit the 10 t as I'm wanting some
For the build the truck is coming along nicely have had the pan powder coated
And whitened the...
Does anyone know of someone in the business of restoring vintage RC motor's? Some motors are getting very hard to find in good cosmetic condition. For some reason Reedy is especially difficult, and when you find them they are very expensive. It...
Last post
You're right it is pretty hard to find just about anything but brushes and bearing for old motors. Someone could steam off some old labels, touch 'em up in Photoshop and reprint them. There's no reason you couldn't do those yourself if you've got a...
I got hold of an original RC10 Worlds (EUR 50, quite the bargain). I'm still torn between making it a shelf queen and building a runner for occasional low-traction track outings with a 13.5 T. Perhaps you could answer some of the questions below....
Last post
1. Soak all the nylon parts in water for a couple days to rehydrate them. The graphite parts should be fine.
2. You'll have to make the call on the o rings. They could be a few years old (re-re) or 30+ years old. If they feel okay, I'd probably...
Amazon [Bot] and 5 guests