RC10Talk - The Net's Largest Vintage R/C Community

I know the 6 gear trans has a much different pitch than my stealth trans. Can someone please tell me what the original tooth count and pitch should be for the pinion and spur gears? Also where can I buy snap ring pliers small enough for the tiny rings in the out drives? Thanks in advance!

yep, the spacers are in there! I think this buggy is almost done....Waiting on the radio now.

Thanks again gomachv! I got it all set up with Deans Connectors. I have a set of springs and spacers for the dog bones. The springs are in the wheel and press against the dog bones but where exactly do these spacers go? I tried to put them in between the spring and dog bone but they fit too tightly ...

Got the esc today no instructions of course....It has a set of red and black wires with tamaiya female connector and a set with bullett females which ones go to battery or motor?

No I didn't know that. So I should remove the slipper clutch bearing and re-install the original bushing?

I made that myself so I wouldn't have to drill a hole for the front post. Just thought this looked much cleaner.

Here it is...

I did go through the stealth trans and found two missing balls so I ordered a new set and replaced them all. Also had the wrong bushing in there (the one for the slipper clutch) so when I installed the new sealed bearing kit I corrected that error. The trans and clutch appear to be in fine working o...

I must be doing something wrong, I tried to post a picture but it isn't showing up.

This is all I have so far: RC10 kit assembled Bought the body on ebay Bought and installed the bearing kit 6 cell 5000mah battery pack is installed Steering servo (not installed but I have it) Waiting on: electronics (2.4 ghz trans/rec, 320A esc w/bec) and Deans plugs If all goes well I hope to have...

Got it! Ordering Deans Plugs! Thanks so much, you guys are the best!

O.K. I can do that! What connectors do you recommend for the Battery connections?

Hey gomachv thanks for the help!!
When you say ignore the caps do you mean to remove it from the plug? Or do you mean just leave it alone?
The motor already has two of them installed and soldered to the case as per the diagram you sent.

O.K. I now have or am waiting on all of the parts to finish my RC10 build. My concern now is how I connect everything. I have set the car up with a 6 cell 7.2V NIMH battery pack. I will also have a 2.4 Ghz radio transmitter and receiver. I have an esc w/bec coming. I will be using the original motor...

Can anyone tell me what size allen wrench fits the rc10 stock motor gear ? It is really tiny. I think the wing attachment allen screws may be the same size also....