RC10Talk - The Net's Largest Vintage R/C Community

Hen's teeth are a piece of piss comparitively. You've got a job on with that one... May be better to sell as spares when you find out what it is. I like a rescue challenge but WOW

These work perfectly on rear axle
1/10 RC Car 12mm Wheel Hex Hub 20mm Extension Adapter RC Rock Crawler SCX10 D90
Via eBay about £7

Optima clone Great Vigor Beagle after a complete stripdown rebuild. No one likes the original body and the one on this was knackered so rather than a pretentious kyosho body might as well go for summat completely different. Buggy special brown dot motor. 2.4 Rx and ESC , running condition. Hi-tech q...

I got FS gt2e which binds with at least 4 fsa3 receivers. Cheap and works. There's an FS A2 tx but takes a lipo battery which seems to be more expensive than the tx it powers so sticking with the AA battery option.
I'm a Ford before Ferrari kinda guy

Ok, own up, who pressed the wrong button and gave me a vote.......no it wasn't me!

Dadio wrote: ↑Sat Feb 27, 2021 9:00 am Think coxbros1 finished the race already a day ahead of everyone else !

I think we should get a urine test for illegal substances....he's taken the piss out of everyone. Well done cox

Truckin hell . Gotta be worth at least one vote juicy. At least you've put the vital organs in.

Zerda with history. I think I'll continue zerda from wreck to runner thread for the rebuild, now where's that screwdriver?

Zerda wreck II
from Switzerland to the UK.
set up as a drift I guess with support/chassis protection strips.
Steering servo with a plug I hadn't seen before.

Shocks cleaned and fitted, not tested for oil seal which is a zerda weakness, still 'first fix' with alien mid deck and kyosho tomohawk driver (dadio's tip). Undecided to go with old or new electronics. Acoms or flysky Just to be a runner Waiting for drive cups for 4wd Thinking of just a bit of grea...

Ct-60 gear box cover, £30 from a US seller. I don't think so, I found a square black plastic flower pot in the shed that'll make bundles.

New cups are a bit longer than zerda parts but fit ok, maybe about 1mm could be ground off the new cups if necessary and 61mm bones seem the norm on the front.

You are not authorised to read this forum.

You are not authorised to read this forum.

A tough decision, I love a good bodge of parts by juiced. But dadio's patience in waiting for 3d printers to produce etc deserves recognition.