RC10Talk - The Net's Largest Vintage R/C Community

it looks like bones might still be available, if so, you can build your own:

asc7379
asc9598
asc7381

Well I finally got it into a running state. Picked up a shorty lipo. This is my first body painted in over 20 years. First time using liquid mask, and first time using an airbrush. I think it turned out pretty good. Its an homage to the box art using colors I like. I still need to find some white st...

If you haven't done the T4 top shaft conversion yet, here is a list of parts you'll need. I just finished mine and it runs great and holds the power of the 13.5T that I'm running on carpet. I found a nearly complete kit on eBay and just needed the top shaft. ASC9601 - Top Shaft ASC7485 - V2 Slipper ...

I cut the front of the battery cup off and also installed servo mounts so the lipo just rests against the steering servo . With a 5200 you may have to cut the bottom out of the rear bulkhead like the re release . I am using a 40c 5000mah Venom with bullet connectors ( 137x46x23 ) .

I use, Turnigy 4000 mAh, 2s 30C, hard case. They fit straight into a unmodified RC10T. https://hobbyking.com/en_us/turnigy-4000mah-2s-30c-hardcase-pack-roar-approved.html?wrh_pdp=2 They are approximately, 5 1/4" x 1 3/4" x 7/8" or 132mm x 49mm x 21mm Before I ordered mine, I cut a pie...