RC10Talk - The Net's Largest Vintage R/C Community

Looking pretty good!

This has been an on and off again project. I was trying to get it race ready last October, but while trying a little stress test on the bench 2 of the side rail joints cracked. So it put a stop to that. While working on it last night I realized I hadn't talked about it much, so here we go. After I w...

Have you opened the bag to see if it's printed on the instructions?

I want to say 1994.

This top deck. Front attaches to a spreader bar that mounts to the bulkhead.

https://www.rc10talk.com/viewtopic.php?f=36&t=41945

Trans and sliders are from an old Badger oval car.

GoMachV wrote: ↑Mon Mar 13, 2023 4:35 pm

scr8p wrote: ↑Mon Mar 13, 2023 3:57 pm Trans and sliders are from an old Badger oval car.

Man, badgers are rare. Rare enough that I don't even know that Ive seen a good pic of one.

So, I've been gifted one these kits by a good dude for helping him out by storing stuff the last 6-7 months or so. I think it's way overpayment for my services, but he disagrees. :lol: I knew it was only a matter of time before someone made this a reality, and Andrew at GP3D really did a nice job wi...

For a servo I have a new Futaba s131s, but I think it may be a bit too old. Seems most guys moved on to the 131sh by then. There's about a dozen guys in the world who would know this, with you being one of them. :lol: That's the problem, I do know . :lol: The 131S was replaced by the 131SH in 1986 ...

So definitely something there. I kind of regretted selling the car. The motor alone was a good conversation piece. I don't know if you saw it, but there is some writing on the label and I swear it could be "Worlds". For all I know, that car ran at the '85 IFMAR Worlds in California. This i...

No.... They're not just boxes. More on these later.

I may have missed it somewhere in the thread, but do you have the proper electronics for it too?

CX-III esc's and ps87 servos were already a hard and pricey find. But with the availability of this kit, for those that really want a Masami replica, at auction..... be prepared to pay.

I may have missed it somewhere in the thread, but do you have the proper electronics for it too? CX-III esc's and ps87 servos were already a hard and pricey find. But with the availability of this kit, for those that really want a Masami replica, at auction..... be prepared to pay. :shock: No, unfo...

The rc10 version was a mid motor set up.

I had the Losi version which was rear motor. Had I kept it, I was gonna work in making it mid.

So what's the plan for the front?

Congrats on the win!