Search found 63 matches
- Sat Nov 30, 2024 6:59 pm
- Jump to forum
- Jump to topic
Re: best way to remove solder from motor cans?
You also can get most of it off with a solder sucker.
- Sat Nov 30, 2024 7:39 pm
- Jump to forum
- Jump to topic
Re: best way to remove solder from motor cans?
Pick yourself up a solder wick, works wonders.
Also make sure your iron is up to the task, a 25w pencil tip iron won't cut it. Use an 80w flat tip, basically the same as what you'd use to solder batteries and 12g connectors would be fine.
Also make sure your iron is up to the task, a 25w pencil tip iron won't cut it. Use an 80w flat tip, basically the same as what you'd use to solder batteries and 12g connectors would be fine.
- Sat Nov 30, 2024 7:43 pm
- Jump to forum
- Jump to topic
Re: best way to remove solder from motor cans?
If you want to save the label, I would honestly just shave it off with a fresh xacto blade, kind of like whittling a stick. Then follow up with a Dremel with a wire wheel or buffer/sanding drum. If you use the drum do it very carefully so you don't dig into the can.