RC10Talk - The Net's Largest Vintage R/C Community

Got the electronics straightened out on the SRB. The Rx, MSC, and servos are from the original car, so nothing mint, just cleaned up a little. Rewired the MSC and new plugs. I think mechanically it just needs the front steering linkage to be complete.

Schrodinger can't find his cat because Aunt Bethany wrapped it up and gave it away as a Christmas gift. :lol: https://static1.srcdn.com/wordpress/wp-content/uploads/2023/12/5-19.jpg?q=50&fit=contain&w=750&h=415&dpr=1.5 I was thinking more...this. David-Fincher-Seven-Box-Far-Out-Maga...

As Ive got some of these, I have measured them.


This 5 spoke design has the hex 8.5mm from the front face


These have the hex 8mm from the front face

I bought a set of those wheels & tires years ago, they're all knockoffs meant to fit HSP/Redcat Racing cars. While they are 12mm hex, they are too big a diameter for vintage RC cars and the wheels are all high positive offset. The rears will rub on your shocks or other chassis parts without usi...

TRX-1-3 wrote: ↑Tue Jun 04, 2024 2:29 am I was thinking more...this.
David-Fincher-Seven-Box-Far-Out-Magazine-3134985009.jpg

Chassis 1506 reporting in. https://i.imgur.com/qRqNYdw.jpg Next to an original, the 40th is outstanding, really smooth suspension and gearbox - looks incredible. https://i.imgur.com/vDLJWT8.jpg Wasn't sure on this when I preordered it, after reading up on the 2013, and CC, but the 40th is the one to...

I bought a set of those wheels & tires years ago, they're all knockoffs meant to fit HSP/Redcat Racing cars. While they are 12mm hex, they are too big a diameter for vintage RC cars and the wheels are all high positive offset. The rears will rub on your shocks or other chassis parts without usi...

some last little M2 and M2.5 stainless steel screws to finish up my 3d printed 8x8 build.

For testing, this was my first use of my SkyRC brushless motor analyzer. Other than adjusting timing, there wasn't much I could do to change the motor run characteristics. I did change rotor shim count/placement a few times to minimize slack and bearing preload. . 1000011357.jpg . For comparison pur...

I was thinking of a brushed motor setup, but changed my mind.
.
https://www.rc10talk.com/viewtopic.php?f=40&t=49543
. .

Those are some cool pictures! Please keep posting these for us non FB people.

I put this project on hold as I wanted to do some final touches. I lowered the body, made a new driver, installed new diff, and sent the wheels out to get the mikesrcworld treatment. He did such an amazing job that I just had to rip open a fresh pack of proline tires and slapped them on along with a...

All wired up. . 1000011482.jpg . 1000011453.jpg . A little test in the house on the carpet showed that this thing might like to wheelie a bit. I need to find a good location to do some outdoor off road testing. . 1000011434.jpg . 1000011435.jpg . 1000011449.jpg . 1000011437.jpg . 1000011446.jpg . 10...

Tonight. 9pm Eastern on the RC10talk YouTube channel. It's going down....

https://youtube.com/@rc10talk?si=QPzOh-2cW5tdu_oh

Congrats R6cowboy!!