RC10Talk - The Net's Largest Vintage R/C Community

The cell shrink size is 52mm long and 43mm wide. I bought this stuff years ago in bulk and have zero clue to its shrink rate. the green pack shrink in the pic i picked up from an ebay seller. https://www.ebay.com/itm/193796032734 here are the sizes and what they shrink too. Width(Dia): 7mm (Ø4mm) 9m...

adam lancia wrote: ↑Sun Mar 03, 2024 5:15 pm Dragging an oldie up from the depths...

Would a 60a sensor ESC be sufficient for a 17.5t combo? No racing, just playing around with my kids.

Thanks in advance!

yes

https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=finger+cut+cots&_sacat=0&_odkw=finger+guards+for+cutting&_osacat=0

They wont prevent pokes and stabs but these work decent to prevent cuts.

1/4" speed bit driver handle!!!!! sorry guys but I'm excited for it. I have honestly been hoping they would make one for years now.

Tamiya TT-02 Alfa Romeo Martini

I still have nightmares from cutting all those decals.

Kraft/Tower Hobbies servo.

3racing Mini MG Evo. Mini 1/10 scale FWD car.

THEYTOOKMYTHUMB wrote: ↑Sun Aug 04, 2024 3:34 pm Well, I'll be the first in the pool. Come on in fellas, the water is piss warm but the beer is ice cold!

poke poke

3racing Mini MG Evo. Mini 1/10 scale FWD car. Wow, that is a huge steering linkage! The steering servo that far back is really wild. I guess that's where there's room and then weight balancing, etc. Ya. The worst is that is actually the third body i bought for the car as the others were just too lo...

3racing Mini MG Evo. Mini 1/10 scale FWD car. Wow, that is a huge steering linkage! The steering servo that far back is really wild. I guess that's where there's room and then weight balancing, etc. Ya. The worst is that is actually the third body i bought for the car as the others were just too lo...

My vintage style dust track.

my Tenth Tech Streetwise Just arrived today. Always wanted a Predator but after years of looking they are just not in my price range. So an economy version it is!

A hot stapler would help add structural support to the area of the bulkhead that was cut.

It will tell you how aligned the hall sensors are as well as actual timing since the notches on motors are always way off. It will also tell you KV at a certain amp draw, most people seem to set the amp draw at 5 - 6 amps to help find the sweet spot which should keep it at a safe-ish temp under rac...