RC10Talk - The Net's Largest Vintage R/C Community

A little more progress last night and today.

Haha! Tribbles!
My Tri-Theme RC10 finalized:


My Curtis Edinger finalized:

Pyxster, The way I do it, is I drill a .08" hole into the body where I want the lights, and then I use 2-56 threaded screws to attach them. The AE fog lights you will need to drill and thread a hole in for the 2-56 screws. If you use the Rough Rider lights as I have here ( the original box art ...

Finalized Curtis Edinger:

Tri-Themed RC10 (Box Art, Curtis Edinger & Winning Edge Car):

Tri-Theme RC10 Completed with Driver:

My 3rd Box Art, 100% airbrushed paint job I did. No "box art stripe decals used"

Held at Darren Stump's home property track, the Florida States Championships gets into the early rounds of qualifying.
https://www.youtube.com/watch?v=rWHpo3ztiMA&ab_channel=RuffyRios

ThrowBackThursday Vintage Race. Today we have the 1990 Florida State Championships 2wd stock A-Main race. This race was held at the G.O.A.R. track in Maitland, Florida. The Greater Orlando Auto Racers (GOAR) organization was a long standing race track that held weekly races for many years. The race ...

Absolutely beautiful work! Thank you very much for posting your build thread. You do amazing work! My "need" list to build one myself is adding up: -Ferrari front white sticker -2x Ferrari side logo stickers -2x Goodyear side stickers -2x front aluminum shock ends/cups -2x steering turnbuc...

Finalized the red re-purposed body/wing buggy, with some additional stickers:

Windows were only removed for the Box art body to give it a realistic look for the photoshoot. That car may have never been run from what we know. But leaving the windows intact (uncut) gives the RC10 the best aerodynamic flow for running, and is what most every racer did.

I do believe the reason for the two holes in the motor plates backside is for tooling, to hold it in the jig while the press comes down to create the two bends. Basically the two holes were for dowels to hold the plate firmly while the press comes down and bends the motor plate at 90 degrees and als...