Chassis id help needed

Post by **Richieflax** » Tue May 11, 2010 5:48 pm

Hi complete newbie needs help!
Can anyone help identify this chassis?

Many thanks

Post by **scr8p** » Tue May 11, 2010 5:52 pm

composite craft, most likely.

Post by **SteveK** » Wed May 12, 2010 5:14 pm

Possibly JG Manufacturing (unless JG just sourced them from CC, which is entirely possible).

Post by **scr8p** » Wed May 12, 2010 5:27 pm

there were so many chassis' for the rc10 back in the day that looked almost identical it's rediculous. someone obviously added the cell slots, and it looks like it had a robinson racing adjustable rear toe setup on it at one time, too.

Post by **Jay Dub** » Wed May 12, 2010 9:03 pm

I am gonna bet it was mid motored at one point. It looks as though there are wear spots in front of where the bulkhead would be (that might also explain the extra rear holes as the bulkhead would have been moved to the rear) and why the cells are so far forward (because of the motor being in the way). My .02 -Jeff

Post by **Richieflax** » Thu May 13, 2010 12:45 pm

Wow, thank you all for your input

This is a fantastic forum

RC10Talk - The Net's Largest Vintage R/C Community

Chassis id help needed

Chassis id help needed

Re: Chassis id help needed

Re: Chassis id help needed

Re: Chassis id help needed

Re: Chassis id help needed

Re: Chassis id help needed

Create an account or sign in to join the discussion

Create an account

Sign in

Who is online