It says it has 5x8 delrin bushes now would this mean i need 5x8x2.5 bearings to go in there as this is the only size i can find that matches on avidrc?
I can wait if needs be but need to put in an order for quite a few bearings so wanted to get it all done in one load.
Just remember, running the GT bellcranks on a 10T will change the geometry a little bit. the 10T bellcranks were a little longer from the pivot to the ball studs than the GT.
Those will be too short if mounted on a RC10T causing bump steer problems without drilling new holes in the chassis. GT holes are much closer to the front bulkhead.
Hmmm i didnt realise this i thought the nose plates were exactly the same and that was why you could use the standard plastic gt bellcranks on the 10t. So if i'm gonna do this i gotta buy me a gt noseplate as i'm not drilling my 10t nose. Is there no other ballraced steering that will bolt on the 10t?
Glad i had some feed back from you guys before i went and bought the steering!
The only ones I seen is from MIP vintage stuff. I was using the stock ones on my RC10T Duratrax conversion until I seen these on Ebay.
I use an A&L steering and made a custom front adjustable bracket.
Just some of the options you can do.
A few years ago I build up a Boost for the race track. On its first race I clipped a side board and snapped the factory steering levers which sadly put the car out of the event.
Not to be beaten I decided to investigate a more reliable system and...
Last post
I have the Race Prep hop-up steering rack, if you would like to compare! :D
Anyone running the jconcepts rc10 alum ballcrank system...
Im wanting to improve my steering with a Jconcepts bell crank upgrade, im assuming the 4-40 ball studs will work, is that correct? do i need any special lengths for them or for the servo to...
I have a big dilemma. I just recently picked up both the Composite Craft and RPM ball bearing steering new sealed for my RC10T, but can't decide which one to open up and install. Which would you guys recommend I go with? Or would the A&L steering...
Last post
I think I'll try the composite craft see how it goes. Thanks
I have been in the process of building a few new runner RC10's and restoring a few more. I really have a hard time finding the steering bell cranks for the tubs. I occasionally see them on E-bay but I always seem to get out bid... Is there another...
I have a black ball bearing steering kitt that came with my team car and the bearings are rusted fom sitting so long. what size are they? anyone have an idea??
Last post
thanks im gonna add them to my Avid order tomorrow.
While building my latest vintage runner, I went in search of a readily-available ball bearing steering setup. Since the old standby MIP RC10 steering kit had been discontinued, I needed to find another solution. I looked at parts from some of the...
Last post
Ok, that makes this kind of pointless now IMO. I just don't think chasing down hard to find parts is worth the slight cost savings.