I really rate the bmax4. In my opinion one of the most satisfying 4wd to drive...shame support for it in the uk is dwindling.
Anyway I purchased a world spec conversion kit some months back (cheers Craig W) and it's taken me ages to install it! Anyhow, enjoy the pics! I've shown some of the key features.
I had a hopped up bmax so this became my recipient of the kit.
The kit includes several options
The new front and rear driveshafts are more durable and the ends are protected by a plastic swivel cap which I'd assume would reduce wear and tear.
Some more nice alloy bling! These are the new upper arm mounts: bit fiddly to install as you have to undo the gear boxes. Two front and two back.
New slipper assembly. Again a little fiddly to assemble but when installed the slipper nut is more accessible which wasn't the case before
Probably not so clear but there are new shock towers which have some plastic shaved off to permit clearance of the new upper arm mounts.
My electrics install. Orion r10 esc, savox servo, spektrum receiver and speed passion 8.5t motor. Wires are a bit messy as I haven't soldered some of them yet!
The conversion kit comes with the new lightweight front cab body. I went with the stock look courtesy of the excellent Mike Parker of number 5 designs...
Ready to roll with some "older brothers"!
