What's up guys. Been while since I posted. Got back to working on my 10Ts and need some advice on a few ideas. Can anyone offer a good metal gear servo to put in the trucks? And looking to change the gear ratio in the tranny (at least that's what I read in some article) How is this done and why would u do it?
Finishing up a partially built 12L4 I snagged on ebay and I planned on putting in a Futaba S3002 metal gear servo. The problem is, the metal spline has really fine threads and a really short screw. The screw is long enough to mount a horn but not a...
Last post
that was a great deal on that L4, I almost bid on it but I want a link car so I can run Lipo. Are you going to come out to Thunder to run it?
Yea, it was thanks. The seller was a little careless and didn't bother to bag the rest of the small...
So I'm rebuilding my original 10Ts for my sons. Going through my parts I found a airtronics servo (94151) that was brand new.. the issue I'm havering is it doesn't fit into my Futaba AM reciever or my novak Fm reciever.. what am I missing or...
Last post
If it has the black black red wires it is wired wrong for futaba which is why the connector won't fit. If it is white red black your OK.
The black black red can be converted by cutting the connector to physically fit and moving the red outer wire...
My old to new build has hit a snag. Ordered a low profile servo from hobby king. It fits but it glitches and makes a lot of gear noise. So I ordered a hitek 77mg low profile. Its nice but its too long. 1.73 instead of a 1.6 Now all I care about is...
Last post
Here are 2 low profile options, while I havent hit a track with my car yet, out front on the asphalt I have no problems whipping the car around.
metal gear
they have a non metal gear version also for under 20, but i dont see an auction for it...
I'm building a lunchbox for my nephew's x-mas present. I'm going to keep it box-stock as he's 7yrs old and doesn't need any additional power. What modern steering servo would you recommend?
Last post
any old standard servo will be fine, if you are using a futaba radio, say a S3003. or whatever is the stock servo with the radio brand you are using. It doesn't usually matter(or shouldn't), but I think its a good idea to stick with the same brand...
Does anyone know of a faster servo than the new KO? Its speed is 0.07 sec. I'm trying to get as close to the throttle response in my rc8, as my rc8e has. any suggestions?
Last post
Does anyone know of a faster servo than the new ko? Its speed is 0.07 sec, Im trying to get as close to the throttle response in my rc8, as my rc8e has. any suggestions?
I'll assume the RC8 is Nitro. So you want your nitro buggy to be as...
Hey guys, I'm looking for a good steering servo for a Rc10T3. I have Dirt Hawg II's on the front. Right now I am running a Hpi SF-1 servo out of my savage x and it doesn't move them as fast and strong as I would like. Any suggestions on a servo?...
Last post
Some things to consider like was mentioned is your steering end points. In the old days you simply remove the servo saver and put all radio settings in the middle. Turn the car on and servo would go to its neutral position. Reinstall the servo...
