I was practicing airbrushing and figured I'd do a couple extra, they are in BST. The blue viper team car body has a very small blemish on the nose. Whatcha think?
Here is the nose blemish:
Here is a better pic of the Red Graphite...
Last post
Finished the original team car ad bodies I'll be keeping for my collection. Thought I'd share.
This build is part of a series of builds I am doing at the same time while sourcing parts. This car will be the biggest challenge because it looks like crap. It is such a bad state and I will need to replace quite a few parts, but I got it for close...
Last post
... It looked like this when I received it today. The horror....
Oh, I dunno, I've seen worse.
You should see some of the junk I drag in the door. :wink:
Do you notice any handling differences between the RC10 graphite team car and the RC10 team car with tub chassis (both fitted with white nylon parts throughout)?
I haven't driven either yet. Been a while...greetings all :)
Last post
I would say the tub chassis has more flex and probably a lot bigger sweet spot for setup
Here's a bit of an unusual one. I received this motor a while back and it has taken a bit of poking around on the Book of Face to find out what it was all about. It turns out three team Demon drivers by the names of Simon Tooley, Chris Boakes and...
Last post
Can't help with the Demon motors but I did see a MG back around 90 that had dual bearings in the endbell.
It was a signature M. Goddard can and a 15 x 2 but can't remember any more. I assumed at the time it was something Mick had done but might have...
Here is one of my newest additions to my RC10 collection.
Got it from a buy now auction right off the bay. I think it is a nice modified car and I got the information that it was driven by a former Italien Team Associated driver.
I will only clean...
Last post
What was the reasoning back in the day for trimming down the chassis. Weight only?
weight was a factor but also being able to get the body down as low as possible helped airflow. You needed all the advantages you could get before the battery...
I bought this new in 1990 I think. It's an Rc10 team car in kit #6035. I have never raced, just enjoyed whoppin all the Tyco's. I would like to clean it up for my son and I, where should I start and where is the cheapest source for parts? Do Hobby...
Last post
Looks like you have most of everything you need to get started. I would get a new battery and charger and give it a go.
Do not know how to formulate this build, but it will be done with NIB parts and some old. No rere parts.
The goal is a out of the box Team car.
Last post
In 1998 I took a Team car to the Washington indoor Nats and Won 9th in the A main stock, It was a 3 day event and was held in Tacoma. The track was built in a old Safway building, If I remember right there was like 500 racers. from all over the...