I have a T3 basher and only managed to break a rear arm mount. By far my most favorite rc. I now run it mostly on the street with a 5700kv Castle and Pro Line Road Rage tires.
I suggest loctite in all of the rear screws. I managed to loosen multiple screws in one run with heavy Gladiator rear tires that were not perfectly balanced. The screws were not just loose, they backed out multiple turns Also, I pushed the lipo all the way forward to eliminate wheelies. You shouldn't have a wheelie problem on clay but the forward position may give better balance.
FYI I was barely able to fit a T4 Bulldog body. The stock front body mount makes for a tight fit due to the extreme angle of the hood.
Good luck!
T3 racer
-
- Approved Member
- Posts: 822
- Joined: Mon Aug 07, 2006 11:05 pm
- Location: Florida
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 71 Replies
- 14371 Views
-
Last post by Qballll
-
- 2 Replies
- 631 Views
-
Last post by CAT3K
-
- 1 Replies
- 434 Views
-
Last post by JK Racing
-
- 5 Replies
- 898 Views
-
Last post by toolman72
-
- 6 Replies
- 1126 Views
-
Last post by Qballll
-
- 14 Replies
- 1382 Views
-
Last post by greazy
-
- 16 Replies
- 1811 Views
-
Last post by BTracer
-
- 30 Replies
- 3919 Views
-
Last post by Tamlok
Who is online
Users browsing this forum: No registered users and 0 guests