Just ordered 2 of these and I have to say for the price that are awesome. I will be equipping more of my cars with these servos as time goes on and money allows.
Finishing up a partially built 12L4 I snagged on ebay and I planned on putting in a Futaba S3002 metal gear servo. The problem is, the metal spline has really fine threads and a really short screw. The screw is long enough to mount a horn but not a...
Last post
that was a great deal on that L4, I almost bid on it but I want a link car so I can run Lipo. Are you going to come out to Thunder to run it?
Yea, it was thanks. The seller was a little careless and didn't bother to bag the rest of the small...
What's up guys. Been while since I posted. Got back to working on my 10Ts and need some advice on a few ideas. Can anyone offer a good metal gear servo to put in the trucks? And looking to change the gear ratio in the tranny (at least that's what I...
Hey guys, I'm looking for a good steering servo for a Rc10T3. I have Dirt Hawg II's on the front. Right now I am running a Hpi SF-1 servo out of my savage x and it doesn't move them as fast and strong as I would like. Any suggestions on a servo?...
Last post
Some things to consider like was mentioned is your steering end points. In the old days you simply remove the servo saver and put all radio settings in the middle. Turn the car on and servo would go to its neutral position. Reinstall the servo...
So do the new metal gear servos no longer require Servo savers?
Last post
I took my time before sending my S6240 Spektrum in for warranty but a mere 3 weeks after sending it in I got it back.
No more rattles!!! Horizon sent me a new servo. I haven't even put the cap back on the receiver yet. Works great.
I finished steering servo shopping for RC10 runner. There are a load of threads on this board on ins and outs of Lipo and Brushless modern amenities for the vintage runners. But not a whole lot on servos frankly. These days you can get metal gears...
Last post
I havent bought a new servo in, 15~20 years (outside of ones in cars I have bought used). I still have my 3 Airtronics 94258/94358 analog monsters. Super quick and very powerful, I run them in my JRX, RC10 and Short Course truck. Recently I went to...
The RC10B2 #9155 black servo saver parts - did anyone ever make an alloy upgrade?
If not, does anyone know of one made for different kit that would work?
9155.jpg
Last post
Are the B2's shorter than an RC10's servo saver? I bought a set of GPM cranks for a Losi Street Weapon to use on a RC10 Terminator build that I wanted to rotate the servo on. The holes were pretty close:
