Hello everybody. I have not posted here for a long time but I seem to have the old RC10 itch again. I posted some photos of one of my RC10’s that I set up for carpet racing back in 2013. I have just read Brian’s thread on his mid motor kit and I’m...
Last post
Welcome!
I'll try to respond to your email a little later today
Looking for tips/set up to run a Rc10 stealth indoors on flat carpet, its a open buggy class at my local club they mainly run touring cars so no jumps :-(
Last post
Too low of a ride height hurts performance, arms level or a few mm below is all you need. If you want to lower the CG use smaller diameter tires if allowed like Custom Works or such. With suspension 5wt heavier and a spring rate or two heavier is...
A few local RC clubs/businesses are putting on our 4th annual RC swap meet this weekend and for the first time, we are going to have a scale crawling expo and a carpet off road track set up for racing. I have raced carpet oval and I have raced off...
Last post
If you are doing oval and not real familiar with setting them up there are some great sources for general setup tips out there. I was never good at oval and I know tweaking the shock adjusters in different corners can change things a lot. In off...
RCCA ran an article sometime around '90-91 where a guy set up an RC10 for indoor carpet oval. I cannot for the life of me remember which model he started with. Maybe a graphite of some sort. Anyway, he replaced the front shocks with tie rods and put...
Last post
Just an FYI:
For a $20 yearly membership, you can download all of RCCA's issues in pdf format from 1986 to 2004. Join here:
Unfortunately, the advertisements are not included, but all the articles are there. I finally finished downloading...
I'm guessing from the sweet polish on the bottom of this it was used mainly on carpet, that and the mega wide stance.
Going to throw in a cheap brushless and have some fun ;-)
The Old Mill and Strohs stickers have got to go! Might just have to get a...
I'm just getting into rc and indoor carpet racing. While looking for a car I found someone with the rc10b6.2D that's barely been used. Would that be good for a carpet track or would I quickly be limited by it and wished I'd spent my...
Last post
I’ve been wandering this path too.. I’d like to race both track types but can’t afford 2 cars. Carpet is rough on ball diffs apparently.