RC10Talk - The Net's Largest Vintage R/C Community

Finished vintage black pan GT exhaust.

...started off in the antifreeze / crock pot.
...steel wool
...then Blue Magic (try it on a test black anno aluminum part too) works good.

Is this the truck?

https://m.youtube.com/watch?v=xvFZjo5PgG0

Nice WNIO build!

What's New Is Old.

I'd be curious if the rere GT trans case fits OG trans parts without shimming or tooling.

I'm sure someone will test this. I didn't buy the rere GT.

Good thread.

The Green Machine. ... You know you raced them

If KISS were an RC10, I'm going with Dual Sport.

There's a thread around here somewhere in which the FanRC shocks are being discussed and there was some talk about the thread pitch of the bodies/caps. It's different or the same as the originals? Anyway, I'll go look for that thread. AE plastic caps might not fit Fan bodies. But I'm not sure of th...

"...but Honey, this is the new gold investment, like the silver I bought a few months back"

Just to confirm, this is an 1/4 x 3/8 x 1/8 (R168ZZ) non-flanged bearing?

Thanks!

Greetings, I have a few aftermarket pan axles that do not have the "seat" for the spur gear. Is there some kind of spacer that should be used to center it on the axle? The OEM ones have the area where the spur seats in the center. All these axles use standard diff rings, but do not have th...

@juicedcoupe

...good thread! Thanks!

@juicedcoupe

I understand what you are saying. With just a race, for the inner outdrive, non-flanged bearing, it would just act like a spacer for the outer flanged one.

...and the large stealth bearing fits right into an unmolested 6 gear case?

Thanks!

Thanks all. I was able to resolve this with the help of the old bushing and Dremel tool. With a Sharpie, I drew a black line all the way around the bushing and inserted it into the outdrive. I was able to see where it was binding the bearing. Visually, I could not see it. It was only the non-flanged...

Hey All, I spent a lot of time replacing bushings for bearings in a 6 gear. On one of the out drives, its motion springs back in the other direction when moving it slowly. I tried 2 sets of bearings, with the same outcome. The out drive is clean as a whistle. The other out drive spins freely with ea...

@jwscab I saw you posted the RFP70N06, as a replacement in this https://www.rc10talk.com/viewtopic.php?t=34048 . I haven't sealed the case yet, but should my OCD kick in, is this a good replacement for this ESC? They are certainly cheap enough. I've been looking at other posts here, it appears the a...