RC10Talk - The Net's Largest Vintage R/C Community

I was looking for a Ultima Pro body, repo is just fine - found one on E-Bay, but it is from Kuwait, that I just do not know about !! I spotted a fellow who was sell in England, but I cannot seem to find the link.
Thanks for the help
Craig

I just picked up a Ultima Pro at the local junk store, in a box with a radio shack monster truck for $20.00. All the Pro is going to need is the upper fiberglass tray and a body. Dave (DW911) has this upper tray for sale and I was wondering if any one (WITH A WHOLE LOT MORE KNOWALGE THAN ME) could t...

Will this mod work on a Ultima Pro also ???? If yes then I just found some wheels for my Ultima Pro

Thanks for the mod
Craig

I love what Opie said "Let's get off this moss covered sh*t hole"
Reminds me of the Great Northwest Costal range, Canada, Washington and Oregon - just about always wet.

Sorry to the Irish Nation for liking that remark !!!!

I think they are cheaper just because most people don't think of them as collectible, therefore the are just old used trucks that are a dime a dozen. Which is fine by me. [/quote]


Me too !!!!!

So I can make a RC-10T out of RC-10GT parts ???? Just need the longer nose piece and a transmission ?? Why are RC-10GT trucks so cheap ??? and RC-10T are not ???

Are RC-10T &GT parts all the same except the frames ???

I don't claim it, but I was born there in the east bay. So I will be a Raider and A's fan untill I die !!! Also a Giants fan when the are not against the A's. That game against Denver, I think was payback for the last few years of "SUCKING", like the Riaders have for soooo long !!! I still...

littleVETTE,
Thanks again for the imput, Like I said before I'm a RC pilot and this RC-10 gold pan is a whole new learning curve for me. I think that I have the tranny a little more loose than what I should have it. I will just keep at it until I'm happy with the way it works

Thanks

I would like to thank both a01butal and littleVETTE for there feedback, my new question would be what should the gear mesh be on both sides ???? I used a caliper when I set up the shafts on the gear plate and they were equal.

I downloaded this article and I'm stuck at #21. Why do you put a 4x40 screw through the diff hub - is that to turn your diff into a posi-track ??? I did everything up to that point - I get about 7-10 seconds of spin out of the diff.

Thanks for the info. Todd !!

The RC Car club here in Bend, Oregon just bult a Big new track and most of the cars are 1/8 nitro truggies, I'm not into them - "BUT" man they sure can take jumps !!! One member has a 1/8 brushless truggy and it sure can keep pace with the nitro cars (I might have to get a electric one som...

Will these stretch onto duratrax 2.2 bx front rims and 2.2 nitro rear rims ??? http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJJ71&P=M http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXJJ70&P=M I would think that they would - the center holes are only .05mm smaller than the outs...

I just purchased a set of duratrax bx front rims and nitro rear rims for my RC-10, like scr8p recommended in his topic ".*Parts needed to run modern 2.2 rims/tires on your rc10*". I followed what SteveK did, in his reply on this topic and did a little surgery on the rear wheels. I first no...