RC10Talk - The Net's Largest Vintage R/C Community

2+2+1=5 1+3+1=5 2+1+2=5 4+2-1=5 no matter if the with is the same or a little big or short is no difference. if you can tell or feel the difeference well you are AMAZING. I bit you spend more time on the bench than running and if you like to run more than deal with finding wheel for your car b4 whee...

its no diference in performance if you use the b4 wheels because what you gain with the new axles you loose it with the wheels at the end what you have is same separation with bigger offset in wheel hope this bring light for those who want to run new wheels and no need to woory about old wheels. ame...

I have evrything to build this project since a long time, but I need enougth time to do that ! http://img293.imageshack.us/img293/5917/img0059qa8.jpg http://img293.imageshack.us/img293/4720/img0060qe0.jpg http://img293.imageshack.us/img293/4939/img0061fl1.jpg http://img293.imageshack.us/img293/6892...

it is possible to fit a B4 body to a old rc10?

please picture if you did it! thanks!

looking for body option

another way to do it without side play from the sway bay.

new updates with photos 3mm+ shock tower B4 shocks front 3mm - shock tower rear with B4 shocks rear sway bar B4 wheel cut down the body to mount in lower tower the rear wing tube where cut down to lower the wing too. PS the car has more travel than before , the original shocks in the back are way to...

hi there! look really nice!!!!! please can you show me how do you install the rear wing, and what wing mount are you using. thanks in advance. I got the idea from another member on this forum. Essentially, I am using standard RC10B4.1 wing mounts. Screw them into the shock tower, which BTW, mine ar...

hi there! look really nice!!!!!


please can you show me how do you install the rear wing, and what wing mount are you using.
thanks in advance.

soniccj5 wrote:You might want to check out Toasted Coasties build.

http://www.rc10talk.com/viewtopic.php?f=35&t=16956&hilit=b4+transmission&start=15

thanks

there are a bunch of threads where guys have done that pretty easily. you would need to either cut a hole in the bottom of the chassis, or mount the trans on a small plate with a hole to allow the trans to sit 'flat' on the chassis, and then modify the bulkhead or fab a new rear bulkhead. you may a...

it is possible to run B4 trans in old rc10

maybe new shock tower with hole for the wing and hold the trans or something close?

the front tire are PROLINE

rctenracer wrote:Nice set up and paint . Never seen that tread design before on the front prolines. Are they current or vintage?

current

no problem whatsoever the trick is allow the clutch to spin a little bit and reprogram the ESC to have like 20% brake .. for me is enough brake.

Really I don't have the name of the body.

about the fitting of the lipo is easy just cut the front part of the battery holder and you just holded with some treet nut like the one for TC3.

look the old wing frm ASSOCIATED

any other idea to share with my ... im planning to move to a JR racing servo